STJH stainless T-inlay floor trim showing broad cap and full 9 mm vertical anchoring leg on white

STJH-STAINLESS-STEEL-CLEANROOM-FLOOR-COVER-STRIP-TI25

Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level

A vertical T-leg anchors inside the joint while the top overlaps two equal-height finishes.

Concealed T-leg anchorage
9 mm joint depth
14 or 25 mm face options

About This Product

This stainless transition profile is held within the existing joint cavity rather than fixed through its upper face. The 9 mm vertical leg is pressed into a compatible adhesive, and the lateral top covers the edges of the two adjoining finishes. The arrangement is intended for equal floor heights, distinguishing it from a rounded surface strip used to bridge a small step.

Fitur utama:

Hidden connection

The bonding material sits in the joint cavity, leaving the exposed stainless surface free from screw heads and fixing holes.

Overlapping edge protection

The top bears over both neighboring finishes to shield their meeting edges from direct mechanical contact.

Equal-height detail

The symmetric T form provides an orderly junction when both floor surfaces finish at the same elevation.

Parameter teknis

Material	AISI 304 stainless steel
Section	T-shaped inlay
Visible Width Options	14 or 25 mm
Vertical Leg Height	9 mm
Minimum Joint Depth	9 mm
Standard Length	2500 mm
Attachment	Compatible adhesive within joint cavity
Floor Levels	Equal height
Finish Options	Natural or brushed stainless
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Applications

Consider for equal-level tile, stone and compatible rigid-floor transitions in healthcare corridors and clean support interiors. Remove debris from the cavity before installation and make sure the joint has enough depth for the leg. This cover trim should not replace a designed structural movement joint.

Solutions for Your Application

Visible fasteners interrupt a carefully finished corridor floor.

Use the concealed vertical leg and an appropriate bonding material inside the existing joint.

The profile remains proud because the cavity is shallow or dirty.

Clean and measure the cavity before bonding so that the leg can seat to its full depth.

Pilihan yang tersedia

Select face width, finish and cut length according to the joint opening. Check the neighboring materials and adhesive compatibility so that both the anchorage and edge overlap remain suitable for the floor.

Planning a Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami