STJH stainless T-inlay floor trim showing broad cap and full 9 mm vertical anchoring leg on white

STJH-STAINLESS-STEEL-CLEANROOM-FLOOR-COVER-STRIP-TI25

Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level

A vertical T-leg anchors inside the joint while the top overlaps two equal-height finishes.

Concealed T-leg anchorage
9 mm joint depth
14 or 25 mm face options

견적 요청 제품 찾아보기

About This Product

This stainless transition profile is held within the existing joint cavity rather than fixed through its upper face. The 9 mm vertical leg is pressed into a compatible adhesive, and the lateral top covers the edges of the two adjoining finishes. The arrangement is intended for equal floor heights, distinguishing it from a rounded surface strip used to bridge a small step.

주요 기능

Hidden connection

The bonding material sits in the joint cavity, leaving the exposed stainless surface free from screw heads and fixing holes.

Overlapping edge protection

The top bears over both neighboring finishes to shield their meeting edges from direct mechanical contact.

Equal-height detail

The symmetric T form provides an orderly junction when both floor surfaces finish at the same elevation.

기술 매개변수

Material	AISI 304 stainless steel
Section	T-shaped inlay
Visible Width Options	14 or 25 mm
Vertical Leg Height	9 mm
Minimum Joint Depth	9 mm
Standard Length	2, 500 mm
Attachment	Compatible adhesive within joint cavity
Floor Levels	Equal height
Finish Options	Natural or brushed stainless
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

Applications

Consider for equal-level tile, stone and compatible rigid-floor transitions in healthcare corridors and clean support interiors. Remove debris from the cavity before installation and make sure the joint has enough depth for the leg. This cover trim should not replace a designed structural movement joint.

Solutions for Your Application

Visible fasteners interrupt a carefully finished corridor floor.

Use the concealed vertical leg and an appropriate bonding material inside the existing joint.

The profile remains proud because the cavity is shallow or dirty.

Clean and measure the cavity before bonding so that the leg can seat to its full depth.

사용 가능한 옵션

Select face width, finish and cut length according to the joint opening. Check the neighboring materials and adhesive compatibility so that both the anchorage and edge overlap remain suitable for the floor.

Planning a Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.