English
الألمانية
العربيةالحالي
الفرنسية
الإندونيسية
اليابانية
الكورية
اللغة الملاوية
البرتغالية
الروسية
الإسبانية
التايلاندية
اللغة التركية
اللغة الفيتنامية
Hidden connection
The bonding material sits in the joint cavity, leaving the exposed stainless surface free from screw heads and fixing holes.
STJH-STAINLESS-STEEL-CLEANROOM-FLOOR-COVER-STRIP-TI25
Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level
A vertical T-leg anchors inside the joint while the top overlaps two equal-height finishes.
- Concealed T-leg anchorage
- 9 mm joint depth
- 14 or 25 mm face options
About This Product
This stainless transition profile is held within the existing joint cavity rather than fixed through its upper face. The 9 mm vertical leg is pressed into a compatible adhesive, and the lateral top covers the edges of the two adjoining finishes. The arrangement is intended for equal floor heights, distinguishing it from a rounded surface strip used to bridge a small step.
الخصائص الرئيسية
Overlapping edge protection
The top bears over both neighboring finishes to shield their meeting edges from direct mechanical contact.
Equal-height detail
The symmetric T form provides an orderly junction when both floor surfaces finish at the same elevation.
المعلمات الفنية
| Material | AISI 304 stainless steel |
|---|---|
| Section | T-shaped inlay |
| Visible Width Options | 14 or 25 mm |
| Vertical Leg Height | 9 mm |
| Minimum Joint Depth | 9 mm |
| Standard Length | 2500 mm |
| Attachment | Compatible adhesive within joint cavity |
| Floor Levels | Equal height |
| Finish Options | Natural or brushed stainless |
| التخصيص | متوفر على أساس التطبيق المقصود وبيئة التشغيل. |
Applications
Consider for equal-level tile, stone and compatible rigid-floor transitions in healthcare corridors and clean support interiors. Remove debris from the cavity before installation and make sure the joint has enough depth for the leg. This cover trim should not replace a designed structural movement joint.
Solutions for Your Application
Visible fasteners interrupt a carefully finished corridor floor.
Use the concealed vertical leg and an appropriate bonding material inside the existing joint.
The profile remains proud because the cavity is shallow or dirty.
Clean and measure the cavity before bonding so that the leg can seat to its full depth.
الخيارات المتاحة
Select face width, finish and cut length according to the joint opening. Check the neighboring materials and adhesive compatibility so that both the anchorage and edge overlap remain suitable for the floor.
Planning a Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level specification?
أرسل لنا الأبعاد الخاصة بك، شروط التثبيت، أهداف الأداء والتشطيب السطحي المطلوب.
