Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Hidden connection
The bonding material sits in the joint cavity, leaving the exposed stainless surface free from screw heads and fixing holes.
STJH-STAINLESS-STEEL-CLEANROOM-FLOOR-COVER-STRIP-TI25
Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level
A vertical T-leg anchors inside the joint while the top overlaps two equal-height finishes.
- Concealed T-leg anchorage
- 9 mm joint depth
- 14 or 25 mm face options
About This Product
This stainless transition profile is held within the existing joint cavity rather than fixed through its upper face. The 9 mm vertical leg is pressed into a compatible adhesive, and the lateral top covers the edges of the two adjoining finishes. The arrangement is intended for equal floor heights, distinguishing it from a rounded surface strip used to bridge a small step.
Características clave
Overlapping edge protection
The top bears over both neighboring finishes to shield their meeting edges from direct mechanical contact.
Equal-height detail
The symmetric T form provides an orderly junction when both floor surfaces finish at the same elevation.
Parámetros técnicos
| Material | AISI 304 stainless steel |
|---|---|
| Section | T-shaped inlay |
| Visible Width Options | 14 or 25 mm |
| Vertical Leg Height | 9 mm |
| Minimum Joint Depth | 9 mm |
| Standard Length | 2500 mm |
| Attachment | Compatible adhesive within joint cavity |
| Floor Levels | Equal height |
| Finish Options | Natural or brushed stainless |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Applications
Consider for equal-level tile, stone and compatible rigid-floor transitions in healthcare corridors and clean support interiors. Remove debris from the cavity before installation and make sure the joint has enough depth for the leg. This cover trim should not replace a designed structural movement joint.
Solutions for Your Application
Visible fasteners interrupt a carefully finished corridor floor.
Use the concealed vertical leg and an appropriate bonding material inside the existing joint.
The profile remains proud because the cavity is shallow or dirty.
Clean and measure the cavity before bonding so that the leg can seat to its full depth.
Opciones disponibles
Select face width, finish and cut length according to the joint opening. Check the neighboring materials and adhesive compatibility so that both the anchorage and edge overlap remain suitable for the floor.
Planning a Stainless Steel Cleanroom Floor Cover Strip T-Inlay Equal-Level specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
