STJH AO60 aluminum-oxide epoxy mortar sample with urethane-sealed top and coarse mineral cut edge on white

STJH-HEAVY-DUTY-EPOXY-MORTAR-FLOORING-AO60

Heavy-Duty Epoxy Mortar Flooring 6 mm Aluminum-Oxide

A hard mineral mortar with a urethane-sealed face for routes exposed to concentrated abrasion and repeated impact.

Aluminum-oxide-bearing aggregate blend
Nominal 6 mm trowelled body
Separate urethane surface sealer

About This Product

AO60 contains aluminum-oxide aggregate within an amine-cured epoxy mortar and is installed at a nominal 6 mm. The dense body is trowelled into place before a chemically resistant urethane sealer is applied. Unlike a thin epoxy coating, its coarse mineral structure remains visible through a cut edge. The sealer is part of the system, helping close mortar surface pores rather than replacing the load-bearing body.

主要な特徴

Hard aggregate selection

The mineral blend addresses abrasive contact in routes where scraping and concentrated wheel movement repeatedly attack the same floor strip.

Two material functions

Epoxy mortar provides the body while the urethane finish supplies the exposed cleaning face, keeping these layers distinct in maintenance planning.

Consolidated perimeter work

Hand finishing around columns and equipment bases helps avoid open mortar edges at locations that cleaning tools must reach.

技術的なパラメータ

Resin	Epoxy with amine curing agent
Aggregate	Aluminum oxide with fine mineral aggregate
Nominal Thickness	6 mm
アプリケーション	Trowel-applied mortar
Surface Sealer	Chemical-resistant urethane
Mortar Form	Four-component formulation
Reference Shore D	90-93 for cured reference mortar
Standard Colour Family	Steel or charcoal grey
Base Condition	Dry, mechanically prepared substrate
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

Applications

Intended for heavily used production routes, equipment handling points and clean industrial support zones. It suits locations where rolling and scraping exposure outweigh the need for a thin decorative coating. Any requirement for full waterproofing should be addressed as a separate compatible system layer.

Solutions for Your Application

Repeated steel-wheel traffic is wearing through ordinary coatings.

Use a full-depth hard-aggregate mortar over repaired concrete and keep transition edges properly supported.

Unsealed mortar could collect residue in surface pores.

Include the urethane sealing stage and renew worn local areas before the mortar becomes exposed.

利用可能なオプション

Coordinate cove returns and floor transitions with the mortar depth. Choose the appropriate grey shade and discuss a compatible waterproofing layer where the complete construction must contain liquid.

Planning a Heavy-Duty Epoxy Mortar Flooring 6 mm Aluminum-Oxide specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する