English
الألمانية
العربيةالحالي
الفرنسية
الإندونيسية
اليابانية
الكورية
اللغة الملاوية
البرتغالية
الروسية
الإسبانية
التايلاندية
اللغة التركية
اللغة الفيتنامية
Hard aggregate selection
The mineral blend addresses abrasive contact in routes where scraping and concentrated wheel movement repeatedly attack the same floor strip.
STJH-HEAVY-DUTY-EPOXY-MORTAR-FLOORING-AO60
Heavy-Duty Epoxy Mortar Flooring 6 mm Aluminum-Oxide
A hard mineral mortar with a urethane-sealed face for routes exposed to concentrated abrasion and repeated impact.
- Aluminum-oxide-bearing aggregate blend
- Nominal 6 mm trowelled body
- Separate urethane surface sealer
About This Product
AO60 contains aluminum-oxide aggregate within an amine-cured epoxy mortar and is installed at a nominal 6 mm. The dense body is trowelled into place before a chemically resistant urethane sealer is applied. Unlike a thin epoxy coating, its coarse mineral structure remains visible through a cut edge. The sealer is part of the system, helping close mortar surface pores rather than replacing the load-bearing body.
الخصائص الرئيسية
Two material functions
Epoxy mortar provides the body while the urethane finish supplies the exposed cleaning face, keeping these layers distinct in maintenance planning.
Consolidated perimeter work
Hand finishing around columns and equipment bases helps avoid open mortar edges at locations that cleaning tools must reach.
المعلمات الفنية
| Resin | Epoxy with amine curing agent |
|---|---|
| Aggregate | Aluminum oxide with fine mineral aggregate |
| Nominal Thickness | 6 mm |
| Application | Trowel-applied mortar |
| Surface Sealer | Chemical-resistant urethane |
| Mortar Form | Four-component formulation |
| Reference Shore D | 90-93 for cured reference mortar |
| Standard Colour Family | Steel or charcoal grey |
| Base Condition | Dry, mechanically prepared substrate |
| التخصيص | متوفر على أساس التطبيق المقصود وبيئة التشغيل. |
Applications
Intended for heavily used production routes, equipment handling points and clean industrial support zones. It suits locations where rolling and scraping exposure outweigh the need for a thin decorative coating. Any requirement for full waterproofing should be addressed as a separate compatible system layer.
Solutions for Your Application
Repeated steel-wheel traffic is wearing through ordinary coatings.
Use a full-depth hard-aggregate mortar over repaired concrete and keep transition edges properly supported.
Unsealed mortar could collect residue in surface pores.
Include the urethane sealing stage and renew worn local areas before the mortar becomes exposed.
الخيارات المتاحة
Coordinate cove returns and floor transitions with the mortar depth. Choose the appropriate grey shade and discuss a compatible waterproofing layer where the complete construction must contain liquid.
Planning a Heavy-Duty Epoxy Mortar Flooring 6 mm Aluminum-Oxide specification?
أرسل لنا الأبعاد الخاصة بك، شروط التثبيت، أهداف الأداء والتشطيب السطحي المطلوب.
