STjh compact 2 by 2 foot explosion-proof ULPA FFU with cast motor enclosure and top access panel

STJH-EXPLOSION-PROOF-FFU-2X2-TOPSIDE

Fan Filter Unit 2 × 2 ft Top-Side Explosion-Proof

A compact stainless ULPA module for small hazardous-location clean enclosures with top-side service.

2 x 2 ft compact footprint
Top-side ULPA filter access
Hazardous-location motor enclosure

Perkenalan produk

The 2 x 2 ft model is the smallest accepted footprint in this hazardous-location FFU family. Its 23.72 x 23.63 x 19.86 in stainless housing uses top-side ULPA access and a non-sparking motor in a cast-iron explosion-proof enclosure. The unit is organized around the manufacturer's NEC Class I/Class II, Division 1 family construction; suitability for a specific classified area still depends on the complete ordered configuration and site requirements.

Fitur utama:

Small classified-area format

The square footprint serves compact process enclosures and ceiling bays where a longer unit is unnecessary.

Protected drive assembly

A non-sparking motor is housed in a cast-iron explosion-proof enclosure as part of the cited hazardous-location family.

Top-side maintenance path

The ULPA stage is serviced from above, separating routine access from the clean-air discharge face.

Parameter teknis

Nominal Module Size	2 x 2 ft
External Dimensions	23.72 x 23.63 x 19.86 in
Housing Material	Stainless steel
Final Filter	ULPA
Filter Access	Top side
Electrical Input	120/240 V, single phase, 50/60 Hz
Motor Construction	Non-sparking motor in cast-iron explosion-proof housing
Hazardous-Location Family Basis	NEC Class I/Class II, Division 1 construction
Airflow Direction	Filtered positive-pressure supply
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Applications

Intended for compact hazardous dispensing enclosures, solvent-handling clean zones and small classified ceiling bays requiring filtered positive-pressure supply. The area classification, wiring method, seals and complete equipment assembly must be evaluated together for the actual site.

Solutions for Your Application

A standard cleanroom FFU does not address the electrical hazards of the classified area.Use a configuration based on the cited hazardous-location family and have the complete installed system evaluated for the specific area classification.

Room-side filter access could disrupt the small controlled enclosure.Reserve a safe top-side service route for ULPA replacement and motor access.

Pilihan yang tersedia

Confirm the classified-area basis, voltage, wiring and isolator arrangement, ULPA seal, stainless finish and ceiling connection. Do not select the module independently from the complete hazardous-location installation.

Planning a Fan Filter Unit 2 × 2 ft Top-Side Explosion-Proof specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami