STjh four-row five-eighth-inch chilled-water cooling coil with a shallow cooling core and copper headers on white.

STJH-CHILLED-WATER-COOLING-COIL-4ROW-58IN

Chilled-Water Cooling Coil Four-Row 5/8-Inch

The shallowest selected cooling core for moderate sensible duty and lower air-side pressure loss.

Four-row shallow core
5/8 in copper tubes
Up to 250 psig family duty

Introduction de produit

The four-row chilled-water core provides the shortest casing depth in this cooling-coil trio. Five-eighth-inch copper tubes are available with 0.020-0.049 in wall options and the referenced family supports up to 250 psig operating pressure. With fewer rows than the six- and eight-row models, it favors lower air resistance and modest condensate duty over deep dehumidification.

Key Features

Lower air-side burden

The shorter tube bank reduces resistance compared with deeper latent-cooling coils.

Selectable tube wall

Copper wall options allow the coil to be matched to pressure, corrosion allowance and service life.

Compact condensate section

A shallower wet core requires less AHU depth while still providing planned drain-pan coverage.

Paramètres techniques

Tube Rows	4
Tube Outside Diameter	5/8 in
Tube Wall Options	0.020-0.049 in
Tube Material	Copper
Maximum Operating Pressure	250 psig family basis
Casing	Galvanized or stainless by selection
Fluid	Chilled water
Condensate Requirement	Drain pan below wet coil
Primary Duty	Moderate sensible cooling
Customisation	Disponible en fonction de l'application prévue et de l'environnement d'exploitation.

Applications

For clean AHUs with moderate sensible cooling load, limited section depth or a requirement to minimize fan pressure consumption.

Solutions for Your Application

The four-row core cannot reach the specified dew point during peak latent load.Rate leaving-air temperature and moisture removal; choose six or eight rows where deeper cooling is necessary.

Condensate carries downstream at excessive face velocity.Size the face area for wet-coil velocity and provide a correctly sloped drain pan and eliminator where required.

Options disponibles

Specify capacity, water temperatures, tube wall, fin spacing, circuiting, casing, coating, drain pan and connection orientation.

Planning a Chilled-Water Cooling Coil Four-Row 5/8-Inch specification?

Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.

Parlez à notre équipe