STJH-ATEX-HEPA-H14-610X610X70

Antistatic HEPA Filter for Hazardous Areas 610 × 610 × 70 mm H14 Slim ATEX-Supported

A 70 mm H14 conductive panel for low-depth hazardous-area terminals and compact process equipment.

70 mm shallow profile
600 m3/h at 105 Pa
Stainless protection grids

商品紹介

Unlike the two 292 mm V-bank models, this shallow H14 panel uses an anodized aluminum perimeter and stainless protection grids around a mini-pleat pack. Its 600 m3/h rating and 105 Pa clean drop suit a terminal or equipment position with restricted depth rather than a high-volume AHU bank. Dry sealing and conductive continuity must both be matched to the receiving frame.

主要な特徴

Terminal-scale geometry

The 70 mm depth preserves ceiling or equipment clearance where a conventional deep V-bank cannot be installed.

Protected pleat faces

Stainless grids shield both the media surface and the conductive assembly during handling and routine service.

Low-flow H14 selection

The 600 m3/h duty supports controlled local supply without oversizing a full high-volume filter cell.

技術的なパラメータ

Dimensions	610 x 610 x 70 mm
Efficiency Class	H14
Rated Airflow	600 m3/h
Initial Pressure Drop	105 Pa ±10%
Frame Material	Conductive anodized aluminum
Face Protection	Stainless steel grids
Seal Type	Dry sealing interface
Maximum Operating Temperature	70 C
Moisture Resistance	100% RH
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

Applications

Used in shallow cleanroom terminals, local laminar-flow equipment or process enclosures situated in correctly classified explosive atmospheres. The modest flow favors point-of-use coverage; the room and ignition-risk assessment still governs the final assembly.

Solutions for Your Application

A 292 mm hazardous-area HEPA cell will not fit above the process enclosure.The 70 mm panel reduces installed depth while providing H14 efficiency at a defined 600 m3/h duty.

The metal guard can be earthed while the aluminum perimeter remains isolated.Bond the complete frame-and-grid assembly through the approved mounting contact and test continuity after clamping.

利用可能なオプション

Confirm terminal face dimensions, gasket arrangement, guard orientation, airflow direction, grounding contact and acceptable 600 m3/h duty.

Planning a Antistatic HEPA Filter for Hazardous Areas 610 × 610 × 70 mm H14 Slim ATEX-Supported specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する