STJH-ATEX-HEPA-H14-610X610X70

Antistatic HEPA Filter for Hazardous Areas 610 × 610 × 70 mm H14 Slim ATEX-Supported

A 70 mm H14 conductive panel for low-depth hazardous-area terminals and compact process equipment.

70 mm shallow profile
600 m3/h at 105 Pa
Stainless protection grids

견적 요청 제품 찾아보기

상품 소개

Unlike the two 292 mm V-bank models, this shallow H14 panel uses an anodized aluminum perimeter and stainless protection grids around a mini-pleat pack. Its 600 m3/h rating and 105 Pa clean drop suit a terminal or equipment position with restricted depth rather than a high-volume AHU bank. Dry sealing and conductive continuity must both be matched to the receiving frame.

주요 기능

Terminal-scale geometry

The 70 mm depth preserves ceiling or equipment clearance where a conventional deep V-bank cannot be installed.

Protected pleat faces

Stainless grids shield both the media surface and the conductive assembly during handling and routine service.

Low-flow H14 selection

The 600 m3/h duty supports controlled local supply without oversizing a full high-volume filter cell.

기술 매개변수

Dimensions	610 x 610 x 70 mm
Efficiency Class	H14
Rated Airflow	600 m3/h
Initial Pressure Drop	105 Pa ±10%
Frame Material	Conductive anodized aluminum
Face Protection	Stainless steel grids
Seal Type	Dry sealing interface
Maximum Operating Temperature	70 C
Moisture Resistance	100% RH
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

Applications

Used in shallow cleanroom terminals, local laminar-flow equipment or process enclosures situated in correctly classified explosive atmospheres. The modest flow favors point-of-use coverage; the room and ignition-risk assessment still governs the final assembly.

Solutions for Your Application

A 292 mm hazardous-area HEPA cell will not fit above the process enclosure.The 70 mm panel reduces installed depth while providing H14 efficiency at a defined 600 m3/h duty.

The metal guard can be earthed while the aluminum perimeter remains isolated.Bond the complete frame-and-grid assembly through the approved mounting contact and test continuity after clamping.

사용 가능한 옵션

Confirm terminal face dimensions, gasket arrangement, guard orientation, airflow direction, grounding contact and acceptable 600 m3/h duty.

Planning a Antistatic HEPA Filter for Hazardous Areas 610 × 610 × 70 mm H14 Slim ATEX-Supported specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.