Three-quarter view of deep low-resistance ULPA filter with extended mini-pleat area

Filter udara dan filtrasi kimia

Filter ULPA Rendah Resistance

An extended-area U15 mini-pleat filter engineered to reduce pressure loss in high-recirculation cleanrooms while maintaining uniform airflow across the terminal face.

Extended Media Area
Optimized U15 Resistance
Uniform Pleat Channels
High-Recirculation Duty

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The low-resistance ULPA filter balances U15-class filtration with the fan-energy demands of continuously recirculated semiconductor cleanrooms. A deeper mini-pleat pack provides increased effective area, and calibrated hot-melt separators keep each narrow air channel open at design flow. The pack is bonded into a rigid anodized-aluminium frame and protected by low-obstruction faceguards. Careful pleat density, pack depth and face velocity selection reduce resistance without thinning the filter structure or compromising clean terminal airflow.

Fitur utama:

A deeper extended-area pack lowers the velocity through each square metre of ultra-fine media.

Calibrated separator spacing prevents narrow pleat channels from pinching under operating pressure.

Low-obstruction protective grids shield the pack while preserving an open discharge area.

The rigid aluminium perimeter maintains a flat seal plane in large ceiling and FFU modules.

Solusi untuk aplikasi Anda

Because recirculation fans operate continuously, even a modest unnecessary pressure loss across each ULPA terminal becomes a significant energy penalty.

U15 filters force FFU motors to operate near their upper speed range.Extended media area reduces local velocity and preserves more available fan pressure.

Aggressive pleat spacing creates blocked channels and inconsistent resistance.Controlled hot-melt bead geometry keeps a repeatable clear path between adjacent pleats.

A protective screen blocks too much of the discharge area.A thin open-grid faceguard protects the pack with limited obstruction.

Large ULPA panels bow and lose their perimeter seal.Reinforced aluminium extrusions and bonded corners maintain flatness across the terminal opening.

Aplikasi yang Tipis

High-recirculation semiconductor cleanroomsEnergy-conscious wafer fabrication baysUltra-clean flat-panel display facilitiesPrecision metrology clean spacesLarge fan filter unit arrays

Parameter teknis

Typical construction ranges for an extended-area low-resistance ULPA filter are listed below.

Bahan inti	Extended-area ultra-fine glass-microfibre or ePTFE ULPA media with optimized mini-pleat separators
Ketebalan Panel (Panel Thickness)	90–150 mm overall aluminium-frame depth
Efektif lebar	Lebar muka nominal 305-610mm
Panjang maksimum	Panjang muka nominal hingga 1220 mm
Baja menghadap ketebalan	0.4–0.5 mm low-obstruction coated-steel or stainless faceguard
Kepadatan inti (core density)	Approximately 28–45 kg/m³ equivalent extended-media-pack density
Konduktivitas Termal (Thermal Conductivity)	Approximately 0.032–0.043 W/(m·K) for the dry ULPA media pack
Permukaan selesai	Natural anodized aluminium with clean white or stainless open-grid faceguards
Jenis Bersama	Continuous EPDM gasket, polyurethane gel trough or knife-edge perimeter
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

U15 or U16 filtration classGlass-microfibre or ePTFE media90 mm or 150 mm extended-depth frameGasket, gel or knife-edge terminal seal

Planning a Low-Resistance ULPA Filter specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami