Three-quarter view of a double-flange stainless cleanroom wall sleeve

Aksesoris Instalasi Cleanroom

Cleanroom Wall Sleeve (Lengan Dinding Kamar Bersih)

A double-flange stainless steel sleeve that forms a smooth, durable passage through cleanroom wall panels for pipes and services.

Smooth Hollow Bore
Double Hygienic Flange
304 Stainless Steel
Panel-Edge Protection

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The cleanroom wall sleeve is a rigid stainless tube with broad circular trim flanges at both ends. Installed through a prepared panel opening, it protects the exposed panel core and creates a smooth bore for routing a process pipe, conduit or service line. Continuous welded transitions and brushed surfaces simplify perimeter sealing and wipe-down on both room faces.

Fitur utama:

A continuous stainless bore isolates the service opening from the exposed panel core.

Two broad flanges cover the cut edges on both sides of the partition.

Smooth welded tube-to-flange transitions reduce dirt-catching ledges.

Sleeve diameter and barrel length can be matched to the service and panel thickness.

Solusi untuk aplikasi Anda

A raw hole through an insulated cleanroom panel exposes core material and leaves an irregular perimeter that is difficult to seal and clean.

Cut panel edges release debris or absorb moisture around the penetration.The continuous metal barrel isolates the panel core from the service passage.

Irregular openings leave visible gaps around the pipe route.Broad end flanges cover the cut perimeter and provide consistent sealing faces.

Sharp panel skins can damage cables or small tubing.The smooth finished bore removes exposed sheet-metal edges from the passage.

Fixed stock lengths do not match different wall build-ups.Sleeve length is produced to suit the panel thickness and finish allowance.

Aplikasi yang Tipis

Process-pipe wall passagesClean utility conduitsElectrical service penetrationsInstrument tubing routesHygienic panel openings

Parameter teknis

Typical construction ranges for a double-flange stainless cleanroom wall sleeve are listed below.

Bahan inti	304 or 316L stainless-steel tubular sleeve with welded circular flanges
Ketebalan Panel (Panel Thickness)	40-200 mm compatible partition thickness
Efektif lebar	25-300 mm clear internal bore diameter
Panjang maksimum	Up to 1000 mm sleeve barrel length
Baja menghadap ketebalan	1.00-3.00 mm tube wall and flange fabrication thickness
Kepadatan inti (core density)	Approximately 7900-8000 kg/m³ for stainless steel
Konduktivitas Termal (Thermal Conductivity)	Sekitar 14-17w/(m · K) untuk baja stainless augenitik
Permukaan selesai	Brushed, satin-polished or electropolished stainless-steel surfaces
Jenis Bersama	Through-panel sleeve with welded double trim flanges and sealed perimeter
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

304 atau 316L stainless steelCustom bore diameterFixed or split trim flangeBrushed or electropolished finish

Planning a Cleanroom Wall Sleeve specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami