Three-quarter view of a double-flange stainless cleanroom wall sleeve

클린룸 설치 액세서리

클린룸 벽 슬리브

A double-flange stainless steel sleeve that forms a smooth, durable passage through cleanroom wall panels for pipes and services.

Smooth Hollow Bore
Double Hygienic Flange
304 Stainless Steel
Panel-Edge Protection

견적 요청 제품 찾아보기

상품 소개

The cleanroom wall sleeve is a rigid stainless tube with broad circular trim flanges at both ends. Installed through a prepared panel opening, it protects the exposed panel core and creates a smooth bore for routing a process pipe, conduit or service line. Continuous welded transitions and brushed surfaces simplify perimeter sealing and wipe-down on both room faces.

주요 기능

A continuous stainless bore isolates the service opening from the exposed panel core.

Two broad flanges cover the cut edges on both sides of the partition.

Smooth welded tube-to-flange transitions reduce dirt-catching ledges.

Sleeve diameter and barrel length can be matched to the service and panel thickness.

응용 프로그램 솔루션

A raw hole through an insulated cleanroom panel exposes core material and leaves an irregular perimeter that is difficult to seal and clean.

Cut panel edges release debris or absorb moisture around the penetration.The continuous metal barrel isolates the panel core from the service passage.

Irregular openings leave visible gaps around the pipe route.Broad end flanges cover the cut perimeter and provide consistent sealing faces.

Sharp panel skins can damage cables or small tubing.The smooth finished bore removes exposed sheet-metal edges from the passage.

Fixed stock lengths do not match different wall build-ups.Sleeve length is produced to suit the panel thickness and finish allowance.

일반적인 응용 프로그램

Process-pipe wall passagesClean utility conduitsElectrical service penetrationsInstrument tubing routesHygienic panel openings

기술 매개변수

Typical construction ranges for a double-flange stainless cleanroom wall sleeve are listed below.

핵심 재료	304 or 316L stainless-steel tubular sleeve with welded circular flanges
패널 두께	40-200 mm compatible partition thickness
유효 폭	25-300 mm clear internal bore diameter
최대 길이	Up to 1000 mm sleeve barrel length
강철 면면 두께	1.00-3.00 mm tube wall and flange fabrication thickness
코어 밀도	대략 7900-8000 kg/m³ 스테인리스
열전도도 (Thermal Conductivity)	오스테나이트 스테인리스를 위한 대략 14-17 W/(m · K)
표면 마무리	Brushed, satin-polished or electropolished stainless-steel surfaces
접합 유형	Through-panel sleeve with welded double trim flanges and sealed perimeter
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

304 또는 316L 스테인리스Custom bore diameterFixed or split trim flangeBrushed or electropolished finish

Planning a Cleanroom Wall Sleeve specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.