Aksesoris Instalasi Cleanroom

Cleanroom Panel Clamp

A reusable stainless-steel bridge clamp that holds adjacent sandwich-panel edges in alignment while their joint is fixed and sealed.

Reusable Installation Tool
Opposed Edge Jaws
Threaded Force Control
No Permanent Face Fixing

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The cleanroom panel clamp is an external installation tool with opposed formed jaws and a threaded adjuster. The jaws bear on protected panel edges while the screw draws adjacent sandwich panels into a stable working position. Installers can therefore check face alignment, close the joint and complete concealed fixing before removing the clamp, without leaving the tool as part of the finished enclosure.

Fitur utama:

Opposed hooked jaws engage both panel edges without relying on a permanent surface fastener.

A coarse threaded adjuster provides progressive, controllable closing force during alignment.

Stainless construction tolerates repeated handling and can be cleaned between installation areas.

Replaceable contact pads or protected jaw faces can reduce marking on coated steel skins.

Solusi untuk aplikasi Anda

Lightweight insulated panels can move or develop a face step before concealed joint hardware and sealant have secured the assembly.

Two panel faces drift out of plane while the concealed fixing is tightened.The bridge clamp holds both edges against a common jaw position during fastening.

Uncontrolled leverage can dent thin coated-steel facings.Threaded adjustment applies force gradually, with jaw pads selected for the facing finish.

Temporary screws leave holes that require hygienic repair.External jaws grip removable edge locations without adding permanent face penetrations.

Different panel thicknesses make a fixed-gap tool impractical.Jaw reach, bridge width and screw travel can be matched to the installed panel system.

Aplikasi yang Tipis

Cleanroom wall-panel erectionCeiling panel edge alignmentModular enclosure assemblyJoint sealing preparationDoor and window infill installation

Parameter teknis

Typical construction ranges for a reusable stainless cleanroom sandwich-panel alignment clamp are listed below.

Bahan inti	304 stainless-steel bridge, opposed formed jaws and threaded adjuster
Ketebalan Panel (Panel Thickness)	50-150 mm compatible sandwich-panel thickness
Efektif lebar	60-240 mm adjustable jaw span
Panjang maksimum	Up to 500 mm overall clamp bridge length
Baja menghadap ketebalan	2.00-6.00 mm structural clamp component thickness
Kepadatan inti (core density)	Approximately 7900-8000 kg/m³ for stainless-steel components
Konduktivitas Termal (Thermal Conductivity)	Sekitar 14-17w/(m · K) untuk baja stainless augenitik
Permukaan selesai	Brushed or bead-blasted stainless steel with optional non-marking jaw pads
Jenis Bersama	Removable opposed-jaw bridge clamp with threaded mechanical adjustment
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

304 or 316 stainless steelSoft polymer jaw padsHex-bolt or hand-knob adjustmentCustom jaw reach and span

Planning a Cleanroom Panel Clamp specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami