Three-quarter view of a stainless cleanroom panel clamp gripping two sandwich-panel edges

클린룸 설치 액세서리

클린 룸 패널 클램프

A reusable stainless-steel bridge clamp that holds adjacent sandwich-panel edges in alignment while their joint is fixed and sealed.

Reusable Installation Tool
Opposed Edge Jaws
Threaded Force Control
No Permanent Face Fixing

견적 요청 제품 찾아보기

상품 소개

The cleanroom panel clamp is an external installation tool with opposed formed jaws and a threaded adjuster. The jaws bear on protected panel edges while the screw draws adjacent sandwich panels into a stable working position. Installers can therefore check face alignment, close the joint and complete concealed fixing before removing the clamp, without leaving the tool as part of the finished enclosure.

주요 기능

Opposed hooked jaws engage both panel edges without relying on a permanent surface fastener.

A coarse threaded adjuster provides progressive, controllable closing force during alignment.

Stainless construction tolerates repeated handling and can be cleaned between installation areas.

Replaceable contact pads or protected jaw faces can reduce marking on coated steel skins.

응용 프로그램 솔루션

Lightweight insulated panels can move or develop a face step before concealed joint hardware and sealant have secured the assembly.

Two panel faces drift out of plane while the concealed fixing is tightened.The bridge clamp holds both edges against a common jaw position during fastening.

Uncontrolled leverage can dent thin coated-steel facings.Threaded adjustment applies force gradually, with jaw pads selected for the facing finish.

Temporary screws leave holes that require hygienic repair.External jaws grip removable edge locations without adding permanent face penetrations.

Different panel thicknesses make a fixed-gap tool impractical.Jaw reach, bridge width and screw travel can be matched to the installed panel system.

일반적인 응용 프로그램

Cleanroom wall-panel erectionCeiling panel edge alignmentModular enclosure assemblyJoint sealing preparationDoor and window infill installation

기술 매개변수

Typical construction ranges for a reusable stainless cleanroom sandwich-panel alignment clamp are listed below.

핵심 재료	304 stainless-steel bridge, opposed formed jaws and threaded adjuster
패널 두께	50-150 mm compatible sandwich-panel thickness
유효 폭	60-240 mm adjustable jaw span
최대 길이	Up to 500 mm overall clamp bridge length
강철 면면 두께	2.00-6.00 mm structural clamp component thickness
코어 밀도	Approximately 7900-8000 kg/m³ for stainless-steel components
열전도도 (Thermal Conductivity)	오스테나이트 스테인리스를 위한 대략 14-17 W/(m · K)
표면 마무리	Brushed or bead-blasted stainless steel with optional non-marking jaw pads
접합 유형	Removable opposed-jaw bridge clamp with threaded mechanical adjustment
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

304 또는 316 스테인리스Soft polymer jaw padsHex-bolt or hand-knob adjustmentCustom jaw reach and span

Planning a Cleanroom Panel Clamp specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.