Anglais
Le portugais
espagnol
Le malais
Indonésien
Allemand
Le turc
Le vietnamien
FrançaisCurrent
russe
Arabe
Thaïlandais
Japonais
Coréen
Drainage de salle blanche, équipement d'hygiène et de sécurité
Eyewash à murpar
A compact wall-supported twin-nozzle eyewash that preserves floor clearance while providing immediate hands-free flushing.
- Space-Saving Wall Mount
- Twin Protected Nozzles
- Stay-Open Push Control
- Stainless Receptor Option
Introduction de produit
The wall-mounted eyewash places the receptor, twin flushing heads and activation valve on a rigid bracket, leaving the floor beneath clear for cleaning and circulation. A large push flag opens a stay-open valve, while flow controls and an inlet strainer stabilize the two streams. Supply and waste connections can pass directly through the wall or remain accessible beneath the receptor according to the service layout.
Key Features
Twin covered heads deliver simultaneous controlled flushing streams.
A stay-open valve leaves both hands free after one-motion activation.
Stainless and chemical-resistant receptor options suit different cleaning chemistries.
Des solutions pour votre application
Small laboratories need an unobstructed emergency flush point without sacrificing activation clarity or service access.
A pedestal unit obstructs narrow aisles and complicates floor cleaning.The load-bearing wall bracket keeps the complete eyewash above the floor.
Emergency users need to operate the station while vision is impaired.A large safety-colored push flag provides a simple tactile activation point.
Water pressure variation can make one nozzle stream stronger than the other.Matched flow controls regulate both heads from the common filtered inlet.
Visible piping can conflict with a clean wall finish.Rear-entry supply and waste routing can conceal services within the technical wall zone.
Les applications typiques
Cleanroom laboratoriesChemical sampling roomsResearch wet benchesCompact utility alcoves
Paramètres techniques
Typical dimensions and materials for a wall-mounted plumbed eyewash are listed below; final wall reinforcement and emergency-water supply are coordinated with the room services.
| Matériaux de base | 304 stainless receptor and bracket with chrome-plated brass valve components |
|---|---|
| Panneau épaisseur | 1.0-1.5 mm stainless receptor |
| Largeur effective | 280-400 mm |
| Longueur maximale | Up to 500 mm projection from wall |
| Acier face épaisseur | 1.0-2.0 mm stainless bowl and mounting bracket |
| Densité Core | 7900-8000 kg/m³ pour les pièces structurelles en acier inoxydable |
| Conductivité thermique | 14-16 W/(m · K) pour les composants en acier inoxydable |
| surface finie | Bright or satin stainless with safety-green activation components |
| Type joint | Bolted wall bracket with threaded inlet, waste and stay-open valve connections |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Rear or bottom service entryStainless or polymer receptorFlow-switch alarm contactTempered-water mixing assembly
Planning a Wall-Mounted Eyewash specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
