STjh four-glove containment isolator with a single side transfer airlock

STJH-NEGATIVE-PRESSURE-CONTAINMENT-ISOLATOR-4G-1AL

Negative-Pressure Containment Isolator 4-Glove with One Airlock

An extended four-glove containment isolator with one shared material airlock for long instrument trains or multi-stage potent processing.

1985 mm extended work zone
Four glove positions
One large transfer airlock

Demander un devis. Browse les produits

Introduction de produit

The four-glove chamber increases the internal working width to 1985 mm while retaining one transfer airlock. It suits processes in which several instruments or consecutive manipulation steps must remain inside a continuous negative-pressure zone, but material entry and exit can share the same interchange under procedural control.

Key Features

Long process deck

Four access positions distribute weighing, processing and pack-off tasks across one sealed chamber.

Shared transfer footprint

A single airlock limits overall width compared with a dual-airlock system while accepting larger staged loads.

Configurable toxic operation

Pressure, filtration and utilities can be arranged for formulation or aseptic-toxic laboratory work.

Paramètres techniques

Work-Zone Dimensions	1985 x 715 x 629 mm
Overall Dimensions	2683 x 955 x 2277 mm with one airlock
Glove Ports	4 process glove positions
Transfer Arrangement	One large material airlock
Operating Pressure	Approximately -60 Pa negative-pressure mode
Filtration	Double HEPA exhaust arrangement
Chamber Construction	Stainless steel work area and transfer airlock
Power Supply	220-240 V AC, 50-60 Hz, up to 3800 W
Control Platform	PLC control with local touchscreen
Customisation	Airlock orientation, glove spacing, utilities and internal process fixtures can be adapted to the intended operating sequence.

Applications

Multi-step HPAPI formulation, extended analytical equipment trains, contained subdivision and aseptic-toxic processing requiring four direct manipulation positions.

Solutions for Your Application

A long process train is difficult to reach from only two glove ports.Four access positions span the 1985 mm chamber so instruments can be assigned to distinct handling zones.

The room cannot accommodate separate infeed and outfeed airlocks.Use the single-airlock architecture and manage bidirectional transfers through a defined batch sequence.

Options disponibles

Large-load airlock fittings, glove selection, H2O2 cycle equipment, balances, service connections and monitoring interfaces are configurable.

Planning a Negative-Pressure Containment Isolator 4-Glove with One Airlock specification?

Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.

Parlez à notre équipe