Anglais
Le portugais
espagnol
Le malais
Indonésien
Allemand
Le turc
Le vietnamien
FrançaisCurrent
russe
Arabe
Thaïlandais
Japonais
Coréen
Accessoires d'installation Cleanroom
duct hanger
An adjustable galvanized trapeze hanger with two threaded rods and a slotted channel crossbar for suspending rectangular cleanroom ductwork.
- Twin Threaded Rods
- Slotted Channel Crossbar
- Independent Level Adjustment
- Galvanized Steel Hardware
Introduction de produit
The duct hanger forms a rigid trapeze below the structural attachment points. Two continuously threaded rods pass through the ends of a galvanized slotted C-channel and are retained by paired nuts and washers, allowing installers to set crossbar elevation and level before the duct is seated. The open channel accepts compatible saddles or restraint hardware without requiring holes to be drilled through the supported duct casing.
Key Features
A slotted C-channel permits flexible positioning of compatible duct restraint hardware.
Broad washer stacks distribute clamping load at the rod-to-channel interfaces.
Zinc-plated steel offers a practical finish for dry indoor service plenums.
Des solutions pour votre application
Rectangular duct runs require a level, distributed support that can be adjusted around uneven overhead structure without puncturing the duct casing.
Fixed-length hangers make it difficult to level ductwork below an uneven soffit.Independent nuts on the two threaded rods allow each end of the channel to be adjusted separately.
Narrow point supports can distort light-gauge rectangular duct walls.The channel crossbar provides a continuous bearing line beneath the duct or its support saddle.
Drilling the duct casing creates avoidable leakage and contamination traps.The trapeze supports the duct externally and accepts separate restraint hardware through its slots.
Bare carbon-steel hardware can develop surface corrosion in service voids.Galvanized or stainless hardware can be selected to suit the plenum exposure.
Les applications typiques
Rectangular cleanroom supply duct suspensionReturn-air duct trapeze supportsExhaust duct support framesAir-handler connection supportService-plenum HVAC installations
Paramètres techniques
Typical construction ranges for an adjustable galvanized cleanroom duct trapeze hanger are listed below.
| Matériaux de base | Galvanized carbon-steel C-channel, threaded rods, nuts, washers and anchor plates |
|---|---|
| Panneau épaisseur | 0.60-2.00 mm compatible rectangular duct wall thickness |
| Largeur effective | 200-1500 mm adjustable duct support width |
| Longueur maximale | Up to 2000 mm slotted channel crossbar length |
| Acier face épaisseur | 1.50-3.00 mm nominal channel wall thickness |
| Densité Core | Approximately 7850 kg/m³ for carbon-steel components |
| Conductivité thermique | Environ 45-60 W/(m · K) pour l'acier au carbone |
| surface finie | Silver electro-galvanized or hot-dip galvanized steel |
| Type joint | Twin threaded-rod trapeze with nut-and-washer clamped slotted channel |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
M8, M10 or M12 threaded rodsElectro-galvanized, hot-dip galvanized or stainless steelCustom crossbar width and slot patternOptional elastomer isolation strip or duct saddle
Planning a Duct Hanger specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
