İngilizce
Almanca
Arapça
Fransızca
Endonezya dilinde
Japonca
Korece
Malay dilinde
Portekizce
Rusça
İspanyolca
Taylandca
TürkçeCurrent
Vietnamca
Filled welded shell
The steel top and shaped bottom pan are welded into an assembly with internal cementitious material, distributing loads through the panel rather than an exposed board edge.
STJH-CEMENT-FILLED-STEEL-RAISED-ACCESS-FLOOR-ST15
Cement-Filled Steel Raised Access Floor 1500 lb
A cement-filled steel access-floor system for moderate equipment loads and regular technical service access.
- 24 inch welded steel panel
- Cementitious internal core
- 1,500 lb system design-duty selection
About This Product
This configuration pairs a 24 x 24 inch welded steel panel with a cementitious core and a 4 ft bolted-stringer understructure. Its reference system duty is 1,500 lb design load, with 900 lb repeated rolling load at 10,000 passes. These values belong to the panel and support arrangement together. The mineral-filled shell offers a distinct construction from woodcore and die-cast aluminum modules.
Ana Özellikler
Defined stringer arrangement
Bolted stringers connect the pedestal layout and support the selected system duty. Matching only the panel dimensions is insufficient when replacing existing floor components.
Moderate rolling-use selection
Repeated wheel movement is a separate criterion from stationary load. Plan trolley routes using the supported rolling duty rather than the headline design-load figure.
Teknik parametreler
| Panel Size | 24 x 24 in (609.6 x 609.6 mm) |
|---|---|
| Maximum Bare Panel Depth | 1-5/8 in (approximately 41.3 mm) |
| Panel Construction | Welded steel shell |
| Internal Fill | Cementitious core |
| Corrosion Protection | Epoxy paint finish |
| Reference Design Load | 1,500 lb on matched system |
| Reference Ultimate Load | 3,000 lb |
| Rolling Load at 10,000 Passes | 900 lb |
| Understructure | 4 ft bolted-stringer system |
| Customization (Özelleşme) | Kullanılan uygulama ve çalışma ortamına göre kullanılabilir. |
Applications
Use in general technical rooms and clean utility areas where moderate equipment movement coexists with frequent cable access. Match wheel type, contact area and travel frequency to the complete flooring arrangement. A nominal 24 inch module is not identical to a 600 mm module, so replacement work requires dimensional compatibility.
Solutions for Your Application
A trolley route is assessed only against the static load number.
Check the repeated rolling criterion and the actual wheel loading before setting the traffic route across the floor.
Replacement panels do not seat correctly in an existing metric grid.
Match the actual 609.6 mm module and support geometry rather than rounding 24 inches down to 600 mm.
Mevcut Seçenekler
Choose the compatible surface finish, pedestal height and prepared service openings. Retain the specified stringer arrangement and use local supports at cut panels or heavily loaded equipment transitions.
Planning a Cement-Filled Steel Raised Access Floor 1500 lb specification?
Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.
