STJH 1500 lb cement-filled steel access-floor panel shown complete with flat top and formed steel underside edge on white

STJH-CEMENT-FILLED-STEEL-RAISED-ACCESS-FLOOR-ST15

Cement-Filled Steel Raised Access Floor 1500 lb

A cement-filled steel access-floor system for moderate equipment loads and regular technical service access.

24 inch welded steel panel
Cementitious internal core
1,500 lb system design-duty selection

Permintaan sebut harga Semak imbas produk

About This Product

This configuration pairs a 24 x 24 inch welded steel panel with a cementitious core and a 4 ft bolted-stringer understructure. Its reference system duty is 1,500 lb design load, with 900 lb repeated rolling load at 10,000 passes. These values belong to the panel and support arrangement together. The mineral-filled shell offers a distinct construction from woodcore and die-cast aluminum modules.

Ciri-ciri Utama

Filled welded shell

The steel top and shaped bottom pan are welded into an assembly with internal cementitious material, distributing loads through the panel rather than an exposed board edge.

Defined stringer arrangement

Bolted stringers connect the pedestal layout and support the selected system duty. Matching only the panel dimensions is insufficient when replacing existing floor components.

Moderate rolling-use selection

Repeated wheel movement is a separate criterion from stationary load. Plan trolley routes using the supported rolling duty rather than the headline design-load figure.

Parameter teknikal

Panel Size	24 x 24 in (609.6 x 609.6 mm)
Maximum Bare Panel Depth	1-5/8 in (approximately 41.3 mm)
Panel Construction	Welded steel shell
Internal Fill	Cementitious core
Corrosion Protection	Epoxy paint finish
Reference Design Load	1,500 lb on matched system
Reference Ultimate Load	3,000 lb
Rolling Load at 10,000 Passes	900 lb
Understructure	4 ft bolted-stringer system
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Applications

Use in general technical rooms and clean utility areas where moderate equipment movement coexists with frequent cable access. Match wheel type, contact area and travel frequency to the complete flooring arrangement. A nominal 24 inch module is not identical to a 600 mm module, so replacement work requires dimensional compatibility.

Solutions for Your Application

A trolley route is assessed only against the static load number.

Check the repeated rolling criterion and the actual wheel loading before setting the traffic route across the floor.

Replacement panels do not seat correctly in an existing metric grid.

Match the actual 609.6 mm module and support geometry rather than rounding 24 inches down to 600 mm.

Pilihan yang boleh didapati

Choose the compatible surface finish, pedestal height and prepared service openings. Retain the specified stringer arrangement and use local supports at cut panels or heavily loaded equipment transitions.

Planning a Cement-Filled Steel Raised Access Floor 1500 lb specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami