STjh 35 mm U17 mini-pleat ULPA filter main product view

STJH-MINI-PLEAT-ULPA-U17-35

Mini-Pleat ULPA Filter 35 mm U17

The highest-efficiency 35 mm ePTFE pack for process tools that require U17 performance and can support its resistance.

U17 highest series grade
0.55 in. w.g. at 100 fpm
Boron-free membrane pack

Solicite un presupuesto. Browse productos

Introducción del producto

This U17 model is the most selective member of the 35 mm ePTFE mini-pleat series, reaching at least 99.999995% efficiency at MPPS. Its nominal clean resistance is 0.55 in. w.g. at 100 fpm, so it should be reserved for contamination-sensitive tools whose risk assessment warrants the airflow penalty. Supported membrane layers and an anodized aluminum perimeter provide a compact filter platform for several seal systems.

Características clave

Minimum penetration tier

U17 acceptance provides the tightest MPPS efficiency in this family for the most sensitive manufacturing steps.

Clearly defined pressure cost

The 0.55 in. w.g. clean value makes the airflow consequence visible before U17 is applied across a ceiling or tool.

Compact protected medium

Scrim-supported ePTFE folds fit a 35 mm pack while resisting damage at the pleat bends during normal handling.

Parámetros técnicos

Efficiency Class	U17
Minimum Efficiency	99.999995% at MPPS
Media Type	Boron-free supported ePTFE membrane
Media Pack Depth	35 mm
Nominal Face Velocity	100 fpm based on net filter area
Nominal Initial Resistance	0.55 in. w.g.
Frame Material	Clear anodized extruded aluminum
Pleat Separation	Polyamide hot-melt beads
Seal Interfaces	Gasket, reverse gel or knife edge
Customization	Disponible según la aplicación prevista y el entorno operativo.

Applications

Reserved for leading-edge semiconductor tools, metrology spaces and mini-environments that explicitly require U17 filtration. System designers should avoid applying it by default where U15 or U16 meets the control target with lower energy use.

Solutions for Your Application

U17 is specified throughout the room even though only a few process tools need it.Map the most sensitive zones and use the U17 panel locally where its 0.55 in. w.g. clean resistance is justified.

The higher-resistance replacement reduces delivered face velocity below the process setpoint.Commission fan output after installation and compare actual flow with the 100 fpm design basis instead of relying on the previous filter setting.

Opciones disponibles

Select exact face and frame dimensions, gasket or gel location, knife-edge form, faceguard, divider and airflow test point.

Planning a Mini-Pleat ULPA Filter 35 mm U17 specification?

Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.

Habla con nuestro equipo