English
Португальский
Испанский язык
Японский
Индонезийский
Немецкий
Турецкий
Вьетнамский язык
Французский
Русский языкТекущий
Арабский язык
Тайский
Японский язык
Корейский
Аксессуары для установки в чистых помещениях
Эпоксидный ремонтный соединение
A two-component resin-and-hardener repair compound for rebuilding small damaged areas before sanding and hygienic surface finishing.
- Metered Two-Part Mixing
- Low-Shrink Hard Cure
- Sandable Repair Surface
- Multi-Substrate Bonding
Введение продукции
Epoxy repair compound combines resin and hardener at a controlled ratio to form a dense thermoset repair material. Dual-cartridge packaging meters both components through a static mixer, reducing incomplete blending on small maintenance jobs. The mixed compound wets properly prepared metal, concrete and rigid panel surfaces, fills chips or localized voids and cures to a hard profile that can be shaped, sanded and overcoated with a compatible hygienic finish.
Основные характеристики
The static mixer produces a uniform blend without a separate mixing cup.
Low curing shrinkage helps the patch retain contact with sound repair edges.
The hardened surface can be machined or sanded before compatible topcoat application.
Решения для вашего приложения
A localized cleanroom repair must bond to a carefully prepared substrate and finish flush without leaving a porous or dirt-catching patch.
Hand-proportioned resin and hardener can remain soft when the ratio is inaccurate.Matched dual cartridges meter both components before they enter the static mixing element.
Oil, dust or weak coating prevents a repair from anchoring to the base material.The defect is cut back to sound material, degreased and mechanically keyed before application.
A proud or rough patch creates a ledge that is difficult to clean.The cured compound is shaped and sanded flush, then closed with a compatible smooth finish.
Large deep fills can overheat or cure unevenly during the exothermic reaction.Repair depth and batch size are limited to the selected grade, with deeper voids rebuilt in controlled stages.
Типичные приложения
Cleanroom panel chip repairLocalized coated-metal defect fillingConcrete floor edge restorationEquipment base and curb repairsRigid frame and trim rebuilding
Технические параметры
Typical construction and application ranges for a cartridge-dispensed two-component epoxy repair compound are listed below.
| Основной материал | Two-component epoxy resin and amine hardener with mineral reinforcement |
|---|---|
| Толщина панели | 1-25 mm practical repair layer thickness |
| эффективная ширина | 5-100 mm typical localized repair width |
| Максимальная длина | Up to 1000 mm continuous localized repair strip per application |
| Толщина линий стали | 0.50-2.00 mm compatible steel repair substrate thickness |
| Плотность ядра | Approximately 1400-2000 kg/m³ mixed compound density |
| Теплопроводимость | Approximately 0.30-0.80 W/(m·K) for cured filled epoxy |
| Поверхностная отделка | Dense sandable gray or off-white surface suitable for compatible overcoating |
| Объединенный тип | Bonded chip, crack, edge or shallow-void repair on sound prepared substrate |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
Dual cartridge or hand-mix packFast or extended working timeGray or off-white compoundStatic mixer and application spatula kit
Planning a Epoxy Repair Compound specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
