Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom Electromagnetic Door Lock Surface-Mounted Single-Leaf
zhengfeng-CLEANROOM-ELECTROMAGNETIC-DOOR-LOCK-SURFACE-SINGLE

Cleanroom Electromagnetic Door Lock Surface-Mounted Single-Leaf

An accessible surface magnet holds a single door against a matched armature, with brackets, power and monitoring selected for the installed opening.
  • Surface installation keeps mounting points accessible.
  • Optional bond monitoring distinguishes magnetic engagement from a simple door contact.
  • A separate armature accommodates the moving leaf.
Request a Quote Browse Products

Surface holding for a single door leaf

A frame-mounted electromagnet attracts a door-mounted armature while DC power is applied. Removing the locking power permits release. The surface format keeps the body and mounting accessible and can suit a retrofit where the frame does not have a suitable concealed pocket.

The magnet is a holding device, not a door closer. Hinges, the closer and the door stops must bring the armature to the magnet consistently. The frame and leaf also need enough support to carry the locking load without their brackets or fixing points moving.

Full face contact matters more than the label alone

The armature must meet the magnet flat and in the intended position. Many designs use a controlled floating attachment to accommodate small alignment differences. Over-tightening that attachment can prevent seating, while loose or incorrect fixings create a different failure. Use the supplied mounting arrangement and adjustment instructions rather than rigidly clamping every part together.

Nominal 600- or 1,200-lbf family ratings describe holding-force classes, not allowable door mass. They are not a rating for the complete installed door under impact, peeling or frame deformation. A stronger magnet cannot correct weak reinforcement or an unsuitable bracket. Define the required holding performance and the complete mounting arrangement together.

Electrical and monitoring choices

ItemSelection detail
ArrangementSingle leaf, surface-mounted magnet and separate armature
Supply12 or 24 VDC version or setting as specified for the selected lock
Holding class600 or 1,200 lbf nominal family reference, subject to the offered model and installation
ReleaseRemoval of locking power through the approved control and emergency arrangement
MonitoringOptional magnetic bond and door-position signals with separate meanings
BracketsSelected for door swing, frame depth, leaf construction and clear opening

Do not assume voltage selection is automatic. Check the model setting before energising and measure the supply at the lock under load. A status relay is a signal output, not necessarily an unlock input. Any suppression device must follow the lock instructions because an unsuitable addition can alter release behaviour.

Door-position monitoring reports whether the leaf has reached a sensing position. Bond monitoring reports the selected magnetic engagement condition. Neither is a direct measurement of room leakage or proof that a required force was achieved in the complete assembly.

Installation, cleaning and acceptance

Coordinate brackets with the usable doorway, seals and any automatic operator. Through-fixings and reinforcement must suit the leaf rather than relying on a thin facing. Keep cleaning access around the exposed body while preventing liquid from entering electrical connections.

At handover, demonstrate normal release, the required emergency path, power loss and restoration, and repeated closing from normal operating positions. Check that bond and position signals change as intended. Inspect mating surfaces, fixings and alignment during maintenance; deposits, corrosion or door sag should be corrected without coating over the magnetic faces.

For a concealed sliding-door installation, compare the recessed magnetic lock. Supply the door section, swing, frame material, required holding class, supply and monitoring needs when requesting a quotation.

Planning your Cleanroom Electromagnetic Door Lock Surface-Mounted Single-Leaf specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us