Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom Electromagnetic Door Lock Concealed Shear-Aligning
zhengfeng-CLEANROOM-ELECTROMAGNETIC-DOOR-LOCK-SHEAR

Cleanroom Electromagnetic Door Lock Concealed Shear-Aligning

A recessed magnet and matched moving armature engage a shear-retaining geometry, with alignment and release tested on the selected door assembly.
  • Alignment features assist engagement at closure.
  • Concealed mounting preserves the surrounding frame line.
  • Dedicated 24 VDC connection with model-specific current data.
Request a Quote Browse Products

Magnetic engagement with a shear-retaining geometry

The concealed shear lock combines an electromagnet with a matched movable armature and engagement features. Magnetic attraction brings the parts together at closure, while the engaged geometry carries the retaining load in shear. The body and armature are recessed into a suitable frame and leaf, reducing visible locking hardware.

This differs from a conventional pull magnet whose holding action depends on broad face contact. The shear arrangement requires the correct approach, gap and freedom of armature movement. Alignment features assist engagement; they do not correct a sagging door, an incorrectly cut pocket or unrestricted variation in the closing position.

Prepare for both engagement and release

Coordinate the pocket, brackets and strike suspension with the exact mounting template. Check the permitted orientation for swing, double-action or sliding applications separately. A geometry intended to work horizontally on a sliding leaf should not be rotated simply to fit the available space.

The door must close to the required position before locking, and the armature must disengage when power is removed. Test under the normal pressure or closer preload expected at the opening. Do not infer reliable release under every load from a nominal holding rating. For powered doors, the controller sequence must release the lock before the operator drives the leaf.

Configuration and load references

ItemSelection basis
MechanismConcealed shear-aligning magnet and matched armature
Supply24 VDC configuration
Current reference84 mA nominal reference at 24 VDC, verified against the selected assembly before circuit sizing
Holding referenceApproximately 600 lbf, or 2.67 kN, nominal force class
Door compatibilityApproved swing or sliding preparation with the required orientation and gap
Release interfaceElectrical removal of locking power with the approved emergency arrangement

A holding value sometimes presented as 272 kg refers to a kilogram-force equivalent, not the permitted mass of a door. The actual assembly needs evidence for the offered lock, mounting and supporting construction. Low nominal current is also not proof that an unspecified controller output, long cable or shared supply is suitable.

Commission the mechanical movement

Observe the armature with power removed, then energised, and then removed again. It should engage and return freely without rubbing or remaining caught. Repeat the check after normal door cycles and with the expected operating preload. Verify any lock-feedback output separately from the door-position switch.

Record the adjusted gap and bracket position with the installation instructions. During maintenance, inspect the suspension, retaining features, screws and mating surfaces for dirt, wear or corrosion. Do not add paint, abrasive damage or an unsuitable lubricant to solve an engagement problem. Correct the door alignment before increasing timing delays.

Include the leaf and frame sections, door action, expected pressure loading, available recess, supply and monitoring requirements in the enquiry. If accessible surface mounting is acceptable, compare the single-leaf surface magnet, which uses a different mounting and holding arrangement.

Planning your Cleanroom Electromagnetic Door Lock Concealed Shear-Aligning specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us