Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom Electric Drop Bolt Lock Heavy-Duty Magnetic-Latch
zhengfeng-CLEANROOM-ELECTRIC-DROP-BOLT-LOCK-HEAVY-MAGNETIC-LATCH

Cleanroom Electric Drop Bolt Lock Heavy-Duty Magnetic-Latch

Magnetic capture steadies the closing leaf before positive bolt engagement, with both door and bolt states available for the control sequence.
  • Magnetic capture assists the final door-positioning step.
  • The larger pin provides a distinct heavy-duty construction.
  • Two monitoring signals help identify incomplete engagement.
Request a Quote Browse Products

Capture the leaf before the deadbolt engages

This heavy-duty electric drop bolt uses magnetic capture to steady the door near its final closing position before a stainless steel pin engages the strike. The capture action and the retaining bolt perform different jobs: one helps establish alignment, while the engaged pin provides positive deadbolting.

The arrangement is useful where a closing leaf tends to rebound or move before locking. It still needs suitable hinges, stops and a controlled approach. Magnetic capture cannot compensate for a large gap, a twisted frame or a closer that drives the leaf violently past the intended position.

A stronger pin needs a stronger installation

The original reference configuration uses a 14.2 mm pin and a 20,000 N nominal holding class. These are component selection references, not a permitted door mass or a rating for the whole partition. The strike pocket, fasteners, frame reinforcement and leaf construction must carry the same load path without local distortion.

Plan the recess and wiring access before panel fabrication. Surface and glass mounting require the corresponding housing and strike accessories. Do not substitute a flat plate for a capture strike simply because the bolt hole appears to align. Horizontal or vertical placement is subject to the selected mounting instructions and approach direction.

Interfaces that affect the result

ItemSelection consideration
Locking sequenceMagnetic capture followed by positive bolt engagement
Supply reference12–24 VDC, checked at the lock during actuation
FeedbackSeparate door-position and bolt-position signals
StrikeMatched capture and bolt geometry with the specified gap
Power-loss behaviourExplicitly selected fail-unlocked or fail-locked version
Control settingsRelock timing and any retry behaviour supported by the offered unit

Starting demand may exceed steady holding demand substantially. A supply that looks adequate from the holding current alone can produce repeated failed engagement. Conversely, a closed-door contact without bolt confirmation points to a mechanical or actuation problem, not successful locking.

Evaluate capture and release separately

During acceptance, observe the leaf arriving, being captured, becoming bolted and releasing. Test slow and normal closing, expected pressure loading, deliberate obstruction and supply interruption. The controller should identify incomplete engagement without continuously driving against an obstruction. Release must be demonstrated under the installed preload, rather than inferred from the retention figure.

Keep capture surfaces and the pin path clean, inspect fasteners and restore door alignment as wear develops. A larger bolt is not a remedy for uncontrolled closure. For a compact monitored bolt without this capture emphasis, compare the monitored stainless steel drop bolt. Supply leaf details, closing conditions and the required failure state when defining this assembly.

Planning your Cleanroom Electric Drop Bolt Lock Heavy-Duty Magnetic-Latch specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us