Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Airtight Cleanroom Door Gasket EPDM Lip-Profile
zhengfeng-AIRTIGHT-CLEANROOM-DOOR-GASKET-EPDM-LIP

Airtight Cleanroom Door Gasket EPDM Lip-Profile

A retained EPDM lip flexes against the closing leaf, with the section matched to the frame groove and actual perimeter gap.
  • A thin contact lip flexes at the sealing face.
  • Groove installation retains the profile along the frame.
  • Passive operation needs no air connection or power.
Request a Quote Browse Products

A flexible lip retained in the frame

This extruded EPDM gasket provides a passive perimeter contact between a compatible frame groove and the closing leaf. The projecting lip bends as the leaf reaches its closed position. It requires no pneumatic supply, making it a practical choice for replacing a worn frame seal where the existing groove and closing geometry remain usable.

Selection starts with the section, not simply the material name. The retaining foot must fit the groove, while lip reach, thickness and direction determine how it meets the door. A profile with the correct overall height can still roll over, pull out or create excessive friction if these details differ.

Balance compliance and operating effort

The listed Shore A 50–70 range is a compound-hardness reference. It does not describe the compression force of the whole extrusion. A thin lip and a solid block of the same hardness behave very differently, and changing lip geometry can alter closing effort more than changing hardness alone.

Too little deflection leaves discontinuous contact; too much can distort the lip, increase opening force and accelerate wear. Establish the gap variation around the actual opening and choose a profile with a suitable working deflection. Do not use the gasket to compensate for a twisted leaf or misaligned hinges.

Information needed for a replacement profile

ItemWhy it is needed
Groove sectionDefines retention dimensions and fitting tolerances
Closed gap and leaf movementDefines lip reach, orientation and rubbing direction
Compound and hardnessEstablishes elasticity and the appropriate material specification
Cleaning exposureIncludes chemical, concentration, temperature and contact time
Corner and splice detailMaintains contact without a stretched or bulky joint
Required performanceDefines any whole-door leakage test and acceptance conditions

EPDM identifies an elastomer family, not universal compatibility with every disinfectant, oil or cleaning process. Use compound-specific compatibility evidence. Likewise, the product name does not establish a quantified airtightness rating for the installed door.

Install without stretching and check the corners

Clean the groove, remove damaged material and seat the retaining foot consistently. Avoid stretching the profile around the opening, which can leave gaps when the rubber relaxes. Use the specified corner or splice method and keep the contact lip continuous at changes of direction.

Check perimeter contact and normal latching after installation, then conduct any specified leakage test at the agreed pressure. During maintenance, look for split lips, shrinkage at joints, permanent deformation and loose retention. Record the section drawing and compound so later replacements preserve the fit. For broader compression contact, compare the hollow silicone profile.

Planning your Airtight Cleanroom Door Gasket EPDM Lip-Profile specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us