Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Airtight Cleanroom Door Gasket Food-Grade Silicone Hollow
zhengfeng-AIRTIGHT-CLEANROOM-DOOR-GASKET-SILICONE-HOLLOW

Airtight Cleanroom Door Gasket Food-Grade Silicone Hollow

A hollow silicone bulb deforms under the closing load to form compliant perimeter contact without pneumatic actuation.
  • Hollow geometry provides room for controlled compression.
  • Silicone construction differs from a solid EPDM lip.
  • The replaceable extrusion can follow a continuous perimeter.
Request a Quote Browse Products

A hollow bulb for passive perimeter compression

The hollow silicone gasket seals by deforming its bulb between the retained profile and the closed door. The cavity gives the section room to deflect and creates a broader contact region than a narrow lip. It remains a passive seal: the leaf and latch provide the closing force, and no air connection inflates the bulb.

The hollow shape is useful when the specified perimeter needs compliant contact, but it must match the gap. Excessive compression can flatten or fold the bulb, raise closing effort and shorten its useful recovery. Too little compression can leave breaks in contact at corners or along a bowed frame.

Specify the compound behind the food-grade description

Food-grade suitability belongs to a defined compound and intended conditions of use. The silicone name, colour or appearance alone does not establish food-contact compliance, medical suitability or compatibility with a cleaning chemical. Where documentation is required, identify the relevant contact conditions and obtain evidence for the actual compound and finished joining process.

The original material reference of approximately −60 to +230°C is not a service rating for every hollow extrusion or door assembly. Published silicone grades differ. Set the working temperature from the offered compound data, exposure duration, joint construction and surrounding components rather than from the broad material-family range.

Section and material choices

ChoiceEffect on the seal
Bulb size and wall thicknessControl the useful compression travel and load
Shore A hardness50–70 reference range, considered with the hollow geometry
Retaining baseMust fit the groove or carrier without pulling loose
Corner constructionMust preserve the bulb shape and continuous contact
Cleaning and temperatureRequire compound-specific limits and compatibility
Evidence scopeMaterial documentation and installed-door leakage are separate checks

Validate a sample on the actual gap

A short fitted sample helps assess retention, compression and operating effort before a complete perimeter is made. Check both the largest and smallest gaps. Joining should not create a hard lump at the corner or a locally collapsed cavity. Adhesive, cure and cleaning requirements need to suit the chosen material.

After fitting, verify that the door closes and latches normally and that the contact line is continuous. Use the agreed pressure and method for any leakage acceptance; a compliant bulb alone cannot guarantee an airtight door. Inspect for cuts, surface tack, swelling or permanent flattening during service. Replace with the recorded section and compound, since a visually similar bulb can have a different compression response.

Planning your Airtight Cleanroom Door Gasket Food-Grade Silicone Hollow specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us