STJH 30 mm polished stainless floor cover strip with adhesive backing and complete rounded ends on white

STJH-STAINLESS-STEEL-CLEANROOM-FLOOR-COVER-STRIP-SA30

Stainless Steel Cleanroom Floor Cover Strip 30 mm Self-Adhesive

An adhesive-backed stainless trim covers a narrow existing floor junction without drilling.

30 mm visible width
Factory adhesive backing
Polished AISI 304 face

견적 요청 제품 찾아보기

About This Product

This 30 mm cover strip has a rounded polished face and a factory adhesive layer beneath it. It bridges the meeting edges of compatible floor finishes while keeping the visible surface free of screws. The slim stainless section is intended for retrofit transitions, including small level differences within the profile's supported geometry, rather than for correcting an uneven or unsupported floor base.

주요 기능

Unbroken exposed face

The adhesive attachment avoids fixing holes through the walking surface, giving the strip a clean continuous appearance.

Quick retrofit placement

After cutting and preparation, the trim is positioned over an existing junction without embedding an anchoring leg beneath the floor.

Rounded crossing surface

The curved top softens the transition over the covered edges compared with a square-edged flat bar.

기술 매개변수

Material	AISI 304 stainless steel
Visible Width	30 mm
Standard Length	2700 mm
표면 마무리	Polished
Attachment	Self-adhesive backing
Cross Section	Rounded cover strip
Floor Relationship	Equal level or up to 5 mm difference
Mounting Position	Over existing joint
Visible Fasteners	None
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

Applications

Consider for interior cleanroom support corridors and existing vinyl, tile or resin junctions where drilling is undesirable. The two surfaces should be firm and clean enough for reliable bonding, with any wax, dust or cleaning residue removed before the adhesive contacts the floor.

Solutions for Your Application

Drilling a finished threshold would disturb the floor or services beneath it.

Use the adhesive-backed strip on a suitable prepared surface and avoid unnecessary penetrations.

The strip lifts at its edges after installation.

Check the level difference, provide full contact and remove adhesion-inhibiting residue before applying firm pressure.

사용 가능한 옵션

Specify cut length, junction width and the actual difference in floor level. Use mechanical fixing instead if the substrate or service conditions cannot provide a dependable adhesive bond.

Planning a Stainless Steel Cleanroom Floor Cover Strip 30 mm Self-Adhesive specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.