English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Unbroken exposed face
The adhesive attachment avoids fixing holes through the walking surface, giving the strip a clean continuous appearance.
STJH-STAINLESS-STEEL-CLEANROOM-FLOOR-COVER-STRIP-SA30
Stainless Steel Cleanroom Floor Cover Strip 30 mm Self-Adhesive
An adhesive-backed stainless trim covers a narrow existing floor junction without drilling.
- 30 mm visible width
- Factory adhesive backing
- Polished AISI 304 face
About This Product
This 30 mm cover strip has a rounded polished face and a factory adhesive layer beneath it. It bridges the meeting edges of compatible floor finishes while keeping the visible surface free of screws. The slim stainless section is intended for retrofit transitions, including small level differences within the profile's supported geometry, rather than for correcting an uneven or unsupported floor base.
Основные характеристики
Quick retrofit placement
After cutting and preparation, the trim is positioned over an existing junction without embedding an anchoring leg beneath the floor.
Rounded crossing surface
The curved top softens the transition over the covered edges compared with a square-edged flat bar.
Технические параметры
| Material | AISI 304 stainless steel |
|---|---|
| Visible Width | 30 mm |
| Standard Length | 2700 mm |
| Поверхностная отделка | Polished |
| Attachment | Self-adhesive backing |
| Cross Section | Rounded cover strip |
| Floor Relationship | Equal level or up to 5 mm difference |
| Mounting Position | Over existing joint |
| Visible Fasteners | None |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Applications
Consider for interior cleanroom support corridors and existing vinyl, tile or resin junctions where drilling is undesirable. The two surfaces should be firm and clean enough for reliable bonding, with any wax, dust or cleaning residue removed before the adhesive contacts the floor.
Solutions for Your Application
Drilling a finished threshold would disturb the floor or services beneath it.
Use the adhesive-backed strip on a suitable prepared surface and avoid unnecessary penetrations.
The strip lifts at its edges after installation.
Check the level difference, provide full contact and remove adhesion-inhibiting residue before applying firm pressure.
Доступные варианты
Specify cut length, junction width and the actual difference in floor level. Use mechanical fixing instead if the substrate or service conditions cannot provide a dependable adhesive bond.
Planning a Stainless Steel Cleanroom Floor Cover Strip 30 mm Self-Adhesive specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
