STJH 600 x 1200 mm 220 V AC fan filter unit with a long rectangular housing against a white background

STJH-AC-FAN-FILTER-UNIT-600X1200-220V

Fan Filter Unit 600 × 1200 mm 220 V AC

A long ceiling module for extended process zones that benefit from fewer separate supply housings.

Long 2:1 module format
220 V PSC drive
One extended HEPA supply face

견적 요청 제품 찾아보기

상품 소개

This approximately 2:1 unit spans a longer roof position and contains a single fan-and-plenum assembly above its final filter. The full-length format is suited to planning repeated ceiling rows or covering a long equipment opening. Its nominal 1200 mm length is distinct from the approximately 1208 mm casing length, so the supporting framework must be sized around the actual housing.

주요 기능

Fewer module boundaries

A single long housing can replace the need to divide a continuous supply opening into two short housings, reducing the number of perimeter interfaces in that position.

Separate structural support

Corner suspension provisions allow the assembly to be supported from the building structure rather than loading the filter face or adjacent ceiling fittings.

Maintainable blower assembly

The fan and inlet service area remain above the room, allowing maintenance access to be arranged alongside the ceiling support system.

기술 매개변수

Nominal Module Size	600 × 1200 mm
Approximate Casing Dimensions	600 × 1208 × 320 mm (W × L × H)
Electrical Supply	220 V AC, single phase; 50 or 60 Hz configuration
Motor Type	Permanent split capacitor AC motor; centrifugal blower
Speed Selection	Three discrete operating speeds
Final Filtration	HEPA, rated capture efficiency 99.99% at 0.3 µm
Inlet Prefilter	Replaceable coarse stage, MERV 7
Housing and Filter Frame	Powder-coated steel body and aluminum filter frame
Filter Replacement Access	Top-service final-filter arrangement
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

Applications

For long equipment covers, electronics production areas and repeated ceiling supply rows where the available opening accommodates the full casing. Multiple modules must be balanced as part of the complete room airflow arrangement; module count alone does not establish a cleanliness class.

Solutions for Your Application

The planned ceiling bay fits a nominal 1200 mm panel but not the longer fan housing.Allow for the approximate 1208 mm casing length, support ledges and sealing surfaces before ordering the ceiling framework.

A long overhead assembly is difficult to lift safely into place.Plan the lift around the housing support points and use independent suspension appropriate to the installed load, keeping lifting contact away from the filter medium.

사용 가능한 옵션

Discuss suspension hardware, perimeter sealing and the electrical connection route for the long housing. Filter specification and installation accessories can be selected for the operating environment without assuming a change to the stated 220 V motor arrangement.

Planning a Fan Filter Unit 600 × 1200 mm 220 V AC specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.