Sistem Dinding dan Langit-langit Cleanroom

Panel Cleanroom H-Type Menghubungkan Profil

An extruded aluminum H-section that receives two opposing cleanroom panels and maintains a straight, protected joint along a modular wall or ceiling run.

Opposed channels for two panel edges
Straight in-plane modular connection
Compatible with multiple panel thicknesses
Sealable exposed joint boundaries

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The H-Type Cleanroom Panel Connecting Profile joins two sandwich panels edge to edge in the same plane. Its opposed channels locate both panel ends, cover exposed core edges and establish a repeatable joint width. The aluminum section can be used in straight wall runs, ceiling infill and removable service bays where a defined mechanical connection is preferred over a tongue-and-groove-only joint.

Fitur utama:

Twin opposed channels align neighboring panels along a common centerline.

The H-section conceals both cut edges and limits direct exposure of the panel core.

A continuous visible face creates a deliberate architectural joint.

Multiple channel sizes accommodate common cleanroom panel thicknesses.

Straight perimeter lands support controlled sealant application on both sides.

Solusi untuk aplikasi Anda

An in-line panel joint must keep two large panels aligned while protecting their edges and maintaining a sealable interface.

Independent panel ends can step out of plane and create a visible ridge.Opposed channels hold both edges against one shared extruded connector.

Cut sandwich-panel cores remain exposed at butt joints.The H-shaped profile encloses both ends within dedicated receiving channels.

A freehand butt joint varies in width over the height of a wall.The fixed extrusion geometry maintains a consistent center joint from end to end.

Replacing one service panel can disturb the neighboring wall module.A defined connector profile separates the panel interfaces and supports modular removal strategies.

Aplikasi yang Tipis

Straight modular cleanroom wall runsCeiling panel connectionsReplaceable service-bay infill panelsControlled-environment partition extensionsConnections between compatible panel modules

Parameter teknis

Channel dimensions are selected to suit the connected sandwich-panel thickness. Thermal values for an insulated panel do not describe this solid aluminum joining component.

Bahan inti	6063-T5 extruded aluminum H-section
Ketebalan Panel (Panel Thickness)	50, 75, 80, 100 or 150 mm compatible variants
Efektif lebar	50 mm typical visible joint face
Panjang maksimum	6000 mm ZXQ000003
Baja menghadap ketebalan	N/A — the connector is an aluminum extrusion
Kepadatan inti (core density)	N/a-tidak ada inti terisolasi; Kepadatan paduan aluminium sekitar 2700 kg/mmaine
Konduktivitas Termal (Thermal Conductivity)	N/a-tidak ada inti terisolasi; Paduan aluminium sekitar 200 W/(m · K)
Permukaan selesai	Electrostatic powder-coated or clear anodized aluminum
Jenis Bersama	Twin opposed H-channels with sealant-ready panel interfaces
Customization (Kustomisasi)	A Tersedia berdasarkan aplikasi dan lingkungan operasi yang dimaksudkan

Pilihan yang tersedia

H-profile for 50 mm panelsH-profile for 75 or 80 mm panelsH-profile for 100 or 150 mm panelsAnodized or powder-coated exposed finish

Planning a H-Type Cleanroom Panel Connecting Profile specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami