Anglais
Le portugais
espagnol
Le malais
Indonésien
Allemand
Le turc
Le vietnamien
FrançaisCurrent
russe
Arabe
Thaïlandais
Japonais
Coréen
Salle blanche HVAC et équipement de manutention de l'air
Tour de refroidissement à contre-courant induite
A compact evaporative heat-rejection tower that draws air upward through wetted fill while condenser water descends into an accessible collection basin.
- Counterflow Air-Water Contact
- Top-Mounted Induced Draft
- Corrosion-Resistant FRP Shell
- Serviceable Fill and Basin
Introduction de produit
The induced-draft counterflow tower uses a top axial fan to draw ambient air upward against warm condenser water distributed above the fill. Evaporation removes heat before cooled water collects in the lower basin and returns to the refrigeration plant. A square FRP casing, removable louvers and modular fill pack provide a compact alternative to crossflow arrangements where footprint matters.
Key Features
The fan at the discharge draws air uniformly through lower inlet louvers and reduces recirculation at the intake.
FRP casing panels and stainless support members resist continuous wet service and treatment chemistry.
Access doors, removable fill cassettes and an open basin support inspection of water-contact components.
Des solutions pour votre application
A cooling tower must reject the design load while controlling footprint, water distribution and maintenance access.
Limited roof area restricts the size of heat-rejection equipment.A vertical counterflow path concentrates fill depth and fan discharge within a compact square plan.
Uneven spray distribution leaves dry fill zones and reduces capacity.A full-coverage header and serviceable nozzles wet the modular fill pack uniformly.
Drift can carry treatment chemicals beyond the tower.Dedicated drift eliminators change exhaust-air direction and capture entrained droplets.
Basin sediment blocks strainers and accelerates corrosion.Accessible sloped basin surfaces, drain points and removable strainers simplify routine cleaning.
Les applications typiques
Cleanroom chiller condenser-water systemsPharmaceutical process-cooling loopsHospital central plantsElectronics-factory HVACIndustrial refrigeration heat rejection
Paramètres techniques
Representative physical construction ranges for a modular counterflow tower are listed below.
| Matériaux de base | PVC fill media inside fiber-reinforced polymer casing |
|---|---|
| Panneau épaisseur | 3-6 mm molded FRP casing panel thickness |
| Largeur effective | 1000-3200 mm nominal tower cell width |
| Longueur maximale | Up to 6500 mm for multi-cell assemblies |
| Acier face épaisseur | 1.5-3.0 mm stainless or hot-dip-galvanized basin/support sheet |
| Densité Core | 30-60 kg/m³ typical PVC fill-pack density |
| Conductivité thermique | Approximately 0.19 W/(m·K) for rigid PVC fill material |
| surface finie | Smooth UV-stabilized FRP exterior with passivated or galvanized hardware |
| Type joint | Bolted gasketed casing panels with modular clipped fill cassettes and flanged water ports |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Single-cell or multi-cell configurationPVC or higher-temperature polypropylene fillVariable-speed fan drive and vibration switchStainless basin, electric basin heater and low-noise fan
Planning a Induced-Draft Counterflow Cooling Tower specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
