STJH-LOW-RESISTANCE-HEPA-H14-GEL610

Low-Resistance HEPA Filter 610 mm Gel-Seal ePTFE

A full-module H14 membrane panel combining low-resistance media with an integral gel-seal channel.

H14 ePTFE membrane
Integral gel channel
Room-side terminal format

Giới thiệu Sản phẩm

This approximately 610 mm square H14 ePTFE panel adds a filled gel trough to the low-resistance membrane construction. The fluid seal accommodates a mating knife edge in bottom-load or room-side replaceable terminals, helping control bypass without relying on gasket compression. It is intended for life-science rooms where terminal access and repeated cleaning make seal geometry a central selection issue.

Các tính năng chính

Fluid bypass barrier

The receiver knife edge enters the continuous gel path to form a seal around the complete filter perimeter.

Low-resistance final media

The ePTFE pack supports high-efficiency supply while limiting the pressure burden on recirculation fans.

Sanitation-oriented access

Room-side changeout can keep service activity out of the congested interstitial space when the housing is designed for it.

Thông số kỹ thuật

Face Format	Approximately 610 x 610 mm
Filter Grade	H14 / at least 99.995% at MPPS
Membrane	Hydrophobic ePTFE
Seal System	Integral fluid gel channel
Frame	Anodized aluminum
Pressure-Drop Profile	Low-resistance membrane configuration
Chemical Environment	Media resistant to common cleaning and decontamination agents
Housing Interface	Mating knife edge into filter gel trough
Service Direction	Bottom-load or room-side replacement
Tùy chỉnh	Có sẵn dựa trên ứng dụng dự định và môi trường hoạt động.

Applications

Used in aseptic filling, sterile pharmaceutical and biotechnology terminals where a room-side replaceable gel seal is preferred. The gel chemistry, knife-edge position and cleaning-agent compatibility must all match the receiving terminal.

Solutions for Your Application

Dry-gasket compression is difficult to inspect in a bottom-load ceiling module.The integral gel channel provides a visible fluid seal path for the housing knife edge.

A reused knife edge carries debris into new gel during changeout.Clean and inspect the mating edge before insertion, then confirm continuous engagement around the full channel.

Các tùy chọn có sẵn

Confirm gel type, channel position, knife-edge dimensions, grille orientation, exact face size and room-side removal hardware.

Planning a Low-Resistance HEPA Filter 610 mm Gel-Seal ePTFE specification?

Gửi cho chúng tôi kích thước của bạn, điều kiện lắp đặt, mục tiêu hiệu suất và bề mặt yêu cầu hoàn thiện.

Nói chuyện với đội ngũ của chúng tôi