STJH-EXHAUST-HEPA-H13-GASKET

Exhaust HEPA Filter H13 Gasket-Seal

A conventional deep H13 exhaust cell for housings that seal the filter by controlled gasket compression.

H13 exhaust duty
Compression gasket interface
Approximate 292 mm depth

Introdução do produto

This exhaust model uses a deep metal enclosure, microglass media and a face gasket rather than a fluid gel interface. It is aimed at standard laboratory and clean-process exhaust where side-access hardware already applies uniform compression to the filter face. The buyer should confirm both the H13 duty and the housing's sealing land before choosing this economical conventional interface.

Características-chave

Familiar changeout method

A face gasket works with common clamping mechanisms and avoids gel-trough inspection during routine non-containment replacement.

Durable deep cell

The rigid metal frame protects the glass-fiber pack against exhaust-bank handling and uneven duct velocity.

Housing-focused sealing

A seamless gasket can close the perimeter only when the rack presents a flat, clean land and consistent clamp travel.

Parâmetros técnicos

Efficiency Class	H13
Filter Media	Moisture-resistant microglass
Nominal Cell Depth	About 292 mm
Frame Material	Galvanized steel or stainless steel
Seal Type	Compression gasket
Pack Sealant	Polyurethane
Recommended Final Pressure Drop	Two times the initial pressure drop
Maximum Operating Temperature	80 C for the cited conventional construction
Installation Interface	Side-access or built-up gasket-clamp housing
Customização	Disponível com base na aplicação pretendida e no ambiente operacional.

Applications

Suitable for general laboratory extract, pharmaceutical support areas and clean manufacturing exhaust where captured material can be handled under the site's normal maintenance controls. It is not a bag-in/bag-out configuration and should not be substituted where the risk assessment demands contained changeout.

Solutions for Your Application

The replacement filter fits the opening but bypass appears around one edge.Check gasket face, land flatness and clamp travel across the full perimeter before accepting the dimensional match.

Maintenance personnel may assume any exhaust HEPA cell is suitable for hazardous dust.Use this conventional gasket model only for the documented exhaust risk; select a compatible containment housing and change method when hazardous loading is present.

Opções disponíveis

Specify exact face size, airflow, frame metal, gasket material and location, faceguards and the housing clamp arrangement.

Planning a Exhaust HEPA Filter H13 Gasket-Seal specification?

Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.

Fale com a nossa equipe