PIR pre-insulated air duct with aluminum foil facings and rigid foam core

Sistemas de Distribuição de Ar para Sala Limpa

Duct de ar pré - isolado PIR

A lightweight rigid duct fabricated from closed-cell PIR panels with aluminum foil facings that combine the air barrier and thermal insulation in one assembly.

Closed-Cell PIR Core
Integrated Thermal Insulation
Aluminum Foil Facings
Lightweight Panel Assembly

Solicite um orçamento. Browse produtos

Introdução do produto

PIR pre-insulated ductwork is cut and folded from rigid closed-cell panels faced on both sides with aluminum foil. The finished duct eliminates the separate sheet-metal shell and external insulation layer used in conventional systems, reducing installed weight and limiting thermal bridges. Male-female panel edges, aluminum profiles, vapor-tight foil tape and compatible sealant form the longitudinal and transverse joints. The smooth foil interior suits dry conditioned supply and return air where the panel is protected from impact and the selected facing is compatible with cleaning practices.

Características-chave

Low-conductivity PIR foam provides useful thermal resistance with a compact 20–30 mm wall.

Continuous foil facings create clean internal and external surfaces and support vapor control.

The combined duct-and-insulation panel reduces suspended load and installation operations.

Factory-routed grooves and aluminum closure profiles produce accurate corners and branch fittings.

Soluções para sua aplicação

A pre-insulated duct must preserve an uninterrupted vapor barrier and protect its foam edges from air leakage, moisture and jobsite damage.

Separate metal duct and insulation increase ceiling load and labor.One rigid PIR panel performs as the duct wall and thermal insulation layer.

Foil cuts at corners become paths for condensation moisture.Continuous foil tape, formed corner profiles and compatible sealant close every exposed edge.

Foam panels are damaged around hangers and service openings.Load-spreading support saddles and reinforced penetrations protect the low-density core.

Field-made joints vary in alignment and air tightness.Matched edge profiles and controlled cutting templates produce repeatable section geometry.

Aplicações típicas

Indoor cleanroom supply ductsReturn-air distributionLow-load suspended ceiling routesHumidity-controlled HVAC branchesPrefabricated mechanical modules

Parâmetros técnicos

Typical material data for aluminum-faced PIR pre-insulated duct panels are listed below.

Material principal	Closed-cell polyisocyanurate (PIR) rigid foam
Painel de espessura	20–30 mm
Largura efetiva	1200 mm de largura padrão do painel
Comprimento máximo	4000 mm standard panel length
Aço enfrentando espessura	0.06–0.20 mm embossed aluminum foil facing on each side
Densidade Core	45–55 kg/m³
Condutividade térmica	0.020–0.023 W/(m·K) at approximately 10–25°C mean temperature
Superfície acabado	Embossed or smooth aluminum foil laminate on internal and external faces
Tipo conjunto	Male-female panel joint with aluminum profile, foil tape and vapor-tight sealant
Customização	Disponível com base na aplicação pretendida e no ambiente operacional.

Opções disponíveis

Antimicrobial coated interior foilReinforced external aluminum facingFlanged equipment connection profilesRectangular fittings and branch modules

Planning a PIR Pre-Insulated Air Duct specification?

Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.

Fale com a nossa equipe