Inglês
Portuguêsatual
Espanhol
Língua malaia
Língua indonésia
Alemão
Língua turca
Vietnã
Francês
Língua russa
Língua árabe
Tailandês
Japonês
Coreano
Equipamento de sala limpa Peças de reposição
Pass Box Porta dobradiça
A robust stainless-steel butt hinge that supports repeated pass box door movement while maintaining stable panel alignment.
- Satin Stainless Construction
- Eight-Point Mounting
- Full-Length Hinge Pin
- Stable Door Alignment
Introdução do produto
The pass box door hinge connects the transfer-chamber door leaf to its frame and carries repeated opening loads without introducing excessive play. Two machined stainless leaves, eight countersunk fixing points and a continuous pin distribute load along the joint. The satin surface is suitable for routine wipe-down, while the compact butt-hinge geometry fits flush chamber construction. Replacement selection should match leaf dimensions, hole centers, pin axis, door weight, opening angle and the existing frame reinforcement.
Características-chave
Eight countersunk holes allow flush fastener seating without protruding heads.
A continuous pin maintains a consistent pivot axis through repeated operating cycles.
Satin stainless surfaces resist routine cleaning exposure and match pass box interiors.
Soluções para sua aplicação
A replacement hinge must match the existing pivot line and fixing pattern to prevent sagging, rubbing or loss of gasket compression.
A shifted pivot axis causes the door edge to rub the frame.Leaf width, barrel offset and mounting position are matched to the original hinge centerline.
Insufficient fixing support allows the hinge screws to loosen under door weight.Eight countersunk locations spread the load into suitable frame and door reinforcement.
Pin wear creates door play and inconsistent gasket compression.A close-fitting full-length stainless pin provides a stable bearing axis and replaceable service point.
Rough or corroded hardware is difficult to clean in the transfer area.Smooth satin stainless leaves and barrel provide a durable wipe-clean exposed finish.
Aplicações típicas
Porta de caixa de passagem estáticaDynamic pass-through chamber doorsMaterial transfer hatch repairsStainless cleanroom cabinet doors
Parâmetros técnicos
Typical material and dimensional ranges for stainless pass box butt hinges are shown below.
| Material principal | Austenitic stainless-steel leaves, barrel and hinge pin |
|---|---|
| Painel de espessura | 3-6 mm nominal hinge-leaf thickness |
| Largura efetiva | 80-160 mm overall open hinge width |
| Comprimento máximo | Up to 240 mm hinge height |
| Aço enfrentando espessura | 3-6 mm stainless-steel leaf thickness |
| Densidade Core | 7900-8000 kg/m³ for stainless-steel components |
| Condutividade térmica | 14-16 W/(m · K) para aço inoxidável austenítico |
| Superfície acabado | Fine satin brushed stainless steel with deburred edges |
| Tipo conjunto | Two-leaf butt hinge with central knuckle barrel, continuous pin and countersunk fixing holes |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Alternative leaf width and heightCustom countersunk hole centersRemovable or retained pinPolished or satin surface finish
Planning a Pass Box Door Hinge specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
