Inglês
Portuguêsatual
Espanhol
Língua malaia
Língua indonésia
Alemão
Língua turca
Vietnã
Francês
Língua russa
Língua árabe
Tailandês
Japonês
Coreano
Filtros de ar e filtragem química
Filtro HEPA Compressão Gasket
A continuous closed-cell elastomer gasket that compresses between the HEPA frame and housing flange to stop perimeter air bypass.
- Closed-Cell Construction
- Controlled Compression
- Continuous Corner Joint
- Multiple Elastomer Grades
Introdução do produto
The compression gasket is bonded to the upstream or downstream face of a HEPA frame and seals against a flat housing flange. Closed-cell polyurethane, neoprene, EPDM or silicone limits air transmission through the foam itself, while the selected hardness lets the gasket recover after clamping. Mitered, vulcanized or moulded endless corners remove gaps at the perimeter. Adhesive backing holds the profile in position during filter installation.
Características-chave
Defined thickness and hardness provide a predictable compression window.
Endless or sealed mitered corners eliminate open butt joints.
Pressure-sensitive adhesive keeps the profile aligned on the filter frame.
Soluções para sua aplicação
Perimeter leakage can remain even with an efficient filter if the gasket is porous, misaligned or unevenly compressed.
Open-cell foam allows air to pass through the gasket body.Closed-cell polyurethane, neoprene or silicone forms a substantially less permeable seal.
A butt joint opens at the frame corner.Moulded endless or sealed mitered construction closes the entire perimeter.
Over-tightening permanently flattens the gasket.Specified hardness and clamp travel keep compression within the elastic recovery range.
The strip moves out of position while the filter is inserted.A continuous adhesive backing fixes the gasket to the cleaned frame surface.
Aplicações típicas
Gasket-seal HEPA filtersAbsolute filter holding framesSide-access filter housingsCleanroom terminal boxesReplacement filter-bank seals
Parâmetros técnicos
Common material and dimensional ranges for HEPA compression gaskets are listed below.
| Material principal | Closed-cell polyurethane, neoprene, EPDM or silicone elastomer foam |
|---|---|
| Painel de espessura | 5–12 mm uncompressed gasket thickness |
| Largura efetiva | 12–25 mm gasket strip width |
| Comprimento máximo | Up to 5000 mm continuous coil or custom endless perimeter |
| Aço enfrentando espessura | 0.05–0.15 mm reinforced pressure-sensitive adhesive carrier where used |
| Densidade Core | 80–250 kg/m³ closed-cell foam density |
| Condutividade térmica | 0.04–0.08 W/(m·K) depending on elastomer grade |
| Superfície acabado | Smooth black, grey or white closed-cell skin with adhesive backing |
| Tipo conjunto | Moulded endless loop or sealed 45-degree miter joints bonded to the filter frame |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Polyurethane, neoprene, EPDM or siliconeSelf-adhesive strip or moulded loopFlat or hollow profileCustom die-cut frame gasket
Planning a HEPA Filter Compression Gasket specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
