Double-Glazed Cleanroom Window 1000 x 1000 mm Silicone-Sealed
- Square proportions suit compact observation positions.
- Both glazed faces align with the partition planes.
- Internal desiccant within the sealed cavity.
A square observation opening with two cleanable faces
This fixed 1000 x 1000 mm double-glazed module provides a view through a cleanroom partition without creating an opening for people, materials or ventilation. Two safety-glass faces are arranged across the wall depth so the installed glazing can meet both wall surfaces. The square format suits observation of a localized task, an entrance or a compact machine position.
The listed size identifies the window module. It is not automatically the clear viewing area or the wall cut-out. The border, supporting profile and installation joint occupy space around the glass; these dimensions belong on the approved opening drawing.
Separate the wall seal from the cavity seal
A silicone joint at the wall perimeter closes the junction between the window and the partition. Inside the assembly, the spacer maintains the separation between panes and exposes the desiccant to cavity air. Desiccant manages incidental cavity moisture; it does not dry the room or compensate indefinitely for a damaged edge seal.
For a conventional dual-sealed insulating-glass construction, moisture resistance depends on the complete edge-seal system, not silicone alone. Establish the supplied construction and the compatibility of the wall sealant with its exposed components. A double-pane cleanroom window should not be assigned an insulating value, gas fill or condensation guarantee without evidence for that assembly.
| Selection item | Basis for this module |
|---|---|
| Nominal width x height | 1000 x 1000 mm; distinguish module, visible glass and prepared opening dimensions. |
| Glazing | Two safety-glass faces; specify glass type, thickness and impact documentation for the location. |
| Depth and alignment | Matched to the finished partition build-up for a flush face on each side. |
| Cavity components | Microperforated spacer and internal desiccant in the listed construction. |
| Site joint | Compatible silicone, with joint geometry and cure conditions stated in the installation detail. |
Install without making the glass carry the wall
The opening needs a sound, square support perimeter. Panel movement, a twisted frame or tightening against an uneven opening can load the glazing locally. Follow the specified support and setting arrangement; a finishing bead is not a substitute for mechanical support. Protect glass edges during handling and keep debris away from bearing surfaces.
Before room release, inspect both faces for alignment, trapped contamination, edge damage and discontinuities in the site seal. Where the partition has a defined air-leakage requirement, include the installed window junction in that acceptance procedure. A smooth joint by itself does not demonstrate pressure performance.
Recognize the location of condensation
Moisture that wipes from a room-facing surface needs a temperature and humidity assessment. Persistent misting between panes points to the sealed cavity and requires investigation of the unit. Record the affected surface before arranging a repair; adding silicone outside the wall joint may not address an internal seal fault.
For quotation, include finished wall thickness, installation height, the two room conditions, cleaning chemicals, glass safety requirements and responsibility for lifting, sealing and replacement access. Compare the 1200 x 1000 mm landscape module when the observation task needs more lateral coverage.
Planning your Double-Glazed Cleanroom Window 1000 x 1000 mm Silicone-Sealed specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.