Die-Cast Aluminum Raised Access Floor Variable-Open-Area
- Factory-defined perforation patterns
- Die-cast aluminum support body
- Compatible 600 mm modular layout
Choose a perforation pattern for each airflow zone
This die-cast aluminum ventilation-panel configuration combines a ribbed body with factory-defined openings on a nominal 600 mm grid. The reference design family covers approximately 3.6–45% free area and 52–60 mm panel depths. These are selection envelopes: each proposed pattern needs a drawing showing its actual openings, ribs and compatible supports.
Variable open area describes a choice of panel patterns, not an adjustable damper built into every panel. The percentage is a geometric ratio. It does not establish an airflow rate, pressure loss or cleanroom classification.
Balance airflow and structural geometry together
A larger opening area can reduce resistance at a given flow, but the result also depends on hole shape, thickness, obstructions and the pressure field. Use a pressure-versus-flow curve for the selected panel and include any covering or regulating accessory. Two panels with the same percentage may not have the same aerodynamic behavior.
Perforations also affect stiffness and available wheel support. Select load evidence for the exact pattern and understructure rather than using a solid-panel rating. Do not enlarge openings on site or cut supporting ribs to achieve an airflow target.
Installation follows the room layout
Place ventilation and solid modules with the final tool footprints, cable trays and return paths on one drawing. A tool base or cable bundle directly below an opening can defeat the intended flow. Match pedestal seating and finished levels where patterns or panel depths change, and keep intended access points reachable.
Choose the finish for the actual cleaning and ESD requirements. A conductive coating needs an effective connection through the installed system; perforated metal alone does not establish personnel grounding. Finish application must leave the specified openings clear.
Commissioning and future changes
Inspect openings and seating surfaces during cleaning without damaging the coating. Record panel locations so a module moved for service returns to the correct airflow zone. Rebalance after significant tool or service changes.
For pricing, identify the quantity of each pattern, depth, finish and support arrangement, plus cut-outs and balancing work. Acceptance should cover measured opening geometry, system load evidence, panel fit and airflow under the final installed pressure conditions. Maintain the approved panel schedule with the room records.
Planning your Die-Cast Aluminum Raised Access Floor Variable-Open-Area specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.