Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Curved Cleanroom Wall Panel 203 mm Radius Composite Corner
zhengfeng-CURVED-CLEANROOM-WALL-PANEL-R203-COMPOSITE

Curved Cleanroom Wall Panel 203 mm Radius Composite Corner

A tall broad arc reduces joints but needs careful handling and movement detailing.
  • Long section reduces horizontal interruption.
  • Wide arc moves joints away from the corner center.
  • Composite substrate accepts a complete interior finish.
Request a Quote Browse Products

A wide-radius tall corner with fewer horizontal joints

The nominal 203 mm corner uses a broad preformed composite arc for a 90-degree internal wall transition. A reference 3048 mm section can cover a ten-foot lining height without an intermediate joint within that section. The eight-inch inner radius provides an open curve, but the resulting footprint must be included in the room layout.

A tall one-piece element reduces seam work while increasing handling demands. Check the delivery route, lifting clearance and support positions before specifying a continuous length. It remains a nonstructural lining: height and rigidity do not make it a support for ceilings, cabinets or process equipment.

Control geometry over the full height

Reference geometryPractical check
203.2 mm inner radiusDefine substrate versus finished surface and verify the available corner footprint.
15.875 mm sectionCoordinate flat lining thickness and joint preparation.
3048 mm reference lengthAgree actual delivered length, end trimming and clearance at the ceiling.
90-degree arc with flat landsSupport the junctions without twisting the formed section.

If the supporting walls are not plumb or square, forcing a long curve into place can distort joints and strain the finish. Resolve those conditions in the framing. Continue the required building movement detail through the corner instead of coating rigidly across it.

Specify the finish and the difficult end details

The floor-cove and ceiling junctions need planned closures so the broad vertical curve does not end in an inaccessible pocket. Tape, joint compound and coating must be compatible with the supplied substrate. The finished surface requires evidence for the proposed cleaning exposure; a painted composite is not automatically a hygienic or fire-rated assembly.

Inspect the full-height transition for joint ridges, coating gaps and damage after installation. Recurrent cracking calls for investigation of movement or support before cosmetic repair. Quote delivery and handling, framing, curved sections, end details and the complete finishing system. Acceptance should compare the installed geometry and cured finish with the approved sample, verify the end closures and document any required wall-performance evidence.

Planning your Curved Cleanroom Wall Panel 203 mm Radius Composite Corner specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us