Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Curved Cleanroom Wall Panel 102 mm Radius Composite Corner
zhengfeng-CURVED-CLEANROOM-WALL-PANEL-R102-COMPOSITE

Curved Cleanroom Wall Panel 102 mm Radius Composite Corner

The compact curved substrate becomes a usable room surface through specified finishing.
  • Small radius uses limited corner space.
  • Flat edge lands simplify seam finishing.
  • Factory forming avoids forcing flat board into a tight bend.
Request a Quote Browse Products

A compact radius substrate for a finished inside corner

The nominal 102 mm corner is a preformed composite section that turns through 90 degrees. It replaces the sharp internal junction with a compact concave surface. Flat joining lands connect the curve to adjoining lining, keeping seam treatment away from the tightest part of the bend.

This is a substrate for a completed wall finish. Screw attachment, joint reinforcement, filling, primer and coating must form a compatible system before the room-facing surface can be assessed for cleaning. A smooth factory curve does not make unfinished seams or an exposed paper layer suitable for the intended cleanroom duty.

Set the radius from the correct surface

Reference geometryCoordination point
Approximately 102 mm inner radiusThe four-inch reference is 101.6 mm; define whether the drawing dimension refers to substrate or finished surface.
90-degree concave turnCheck the actual wall angle before ordering.
12.7 mm reference substrateMatch the adjoining lining and allow for the selected finishing build-up.
Flat edge landsProvide suitable framing and enough area for the specified joint treatment.

A smaller radius occupies less of the corner than a broad arc, but a cleaning tool must still contact the curved surface and the floor junction. Agree a representative sample rather than selecting from the radius alone. The panel is a nonstructural lining and must not be assumed to preserve a fire barrier without applicable assembly evidence.

Support, finish and maintain the transition

Support the edges without forcing the manufactured curve to an incorrect angle. Set fasteners to the approved detail without crushing or delaminating the substrate. Trial the joint and coating system on the actual materials, and allow the specified drying and curing conditions.

Quotation should separate curved substrate, framing, edge preparation, joint treatment and final coating. Acceptance should check radius, alignment, continuous coverage and cleaning compatibility of the cured finish. During service, investigate cracking or soft edges before repainting; a superficial repair cannot correct movement or moisture damage underneath.

Planning your Curved Cleanroom Wall Panel 102 mm Radius Composite Corner specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us