Conductive Epoxy Flooring High-Build Floor Coating
- Nominal 0.8–1.0 mm high-build arrangement
- Conductive wearing material with defined grounding
- Smooth finish assessed for traffic and cleaning
A smooth conductive working surface
HB10 is a high-build epoxy flooring arrangement for indoor areas where a smooth resin surface and an intentional path for static charge are required together. The nominal 0.8–1.0 mm build is a planning reference for this configuration. The installation schedule should identify the wearing-layer thickness and whether the primer is included in that figure. It suits sound, reasonably even substrates where a thick mortar bed is unnecessary.
Conductive components form a network within the specified wearing material. This differs from relying on a periodically applied antistatic polish. The network still needs a compatible connection to the grounding system, and the exposed surface must remain accessible to footwear or other intended contacts. A conductive body cannot overcome an insulating maintenance film laid over it.
Thickness, mixing and surface continuity
Film thickness controls coverage, wear allowance and the continuity of the finished surface. Thin areas over aggregate peaks can develop pinholes or wear through early. Extra thickness is not a reliable way to lower electrical resistance: filler distribution, curing and the connections between layers also matter. Depressions and concrete repairs therefore need correction before the conductive finish is spread.
Premixing and combining the complete components according to the selected formulation help distribute settled conductive material. Substituting filler, changing the resin ratio or straining out functional fibres can alter the network even when the coating still looks uniform. Working time and batch size must allow spreading and finishing before the mixture thickens. Solvent or water additions are acceptable only where the material instructions permit them.
The floor and its grounding connections
The construction normally combines a prepared substrate, compatible primer, defined grounding points and the conductive wearing layer. The exact underlayer arrangement depends on the selected resin system. Record the grounding layout before it is covered, including the treatment of separate rooms, movement joints and isolated bays. A metal strip visible at one edge does not demonstrate continuity across the entire floor.
Substrate moisture and adhesion requirements remain applicable to conductive epoxy. A moisture-control layer, if needed, must be assessed as part of the assembly. Conductive resin is not a substitute for treating water ingress or unstable concrete, and it is not electrical insulating protection.
Specify the electrical result, not a generic resistance label
Resistance to ground and resistance between two surface points describe different paths. IEC 61340-4-1 provides floor resistance measurement methods; it does not supply a universal pass value for every application. The purchase specification should state the required limits, electrode method, conditioning, test locations and acceptance stage. Humidity and cleaning conditions belong in the recorded results rather than being assumed irrelevant.
Where personnel grounding is required, evaluate the intended footwear and floor together using the applicable system method, such as IEC 61340-4-5. Material resistance alone does not establish walking body voltage.
Keep the surface serviceable
The smooth finish assists routine cleaning, but tyre deposits, wax and cleaner residue can change electrical contact. Use an approved cleaning method and retest repaired or recoated areas. For procurement, define wheel loads, turning traffic, chemicals, colour and repair access alongside the electrical requirement. Low-emission cleanroom use or aggressive chemical exposure requires additional evidence for the selected assembly; neither follows automatically from a conductive designation.
Planning your Conductive Epoxy Flooring High-Build Floor Coating specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.