Conductive Epoxy Flooring Low-Emission Cleanroom
- Nominal 1.5 mm self-smoothing wearing layer
- Emission evidence matched to the cleanroom process
- Particle generation and static control assessed separately
Choose the floor around the contamination-sensitive process
CR15 is a smooth conductive epoxy flooring configuration for cleanroom projects, using a nominal 1.5 mm self-smoothing wearing layer. Its selection involves two separate questions: whether the installed floor provides the required static-control path, and whether its materials and service behaviour are suitable for the process contamination limits. Optical assembly, precision electronics and controlled medical production may attach very different importance to airborne chemicals and abrasion particles.
The wearing-layer figure does not represent every primer, repair or moisture-control layer beneath it. Those materials, together with coving and joint details, belong in the proposed construction. A cleanroom floor should be assessed as that complete arrangement rather than as a finish colour sample alone.
Low VOC content and low emissions are different evidence
VOC content describes substances in the supplied coating under a stated measurement method. Emission testing examines what a material releases after application under defined conditions. A high-solids formulation can still release compounds during curing, and a low VOC-content figure does not by itself establish suitability for a process sensitive to particular airborne molecular contaminants.
Useful evidence identifies the tested formulation, cure age, exposure conditions, substances measured and reporting limits. ISO 14644-15 addresses suitability of equipment and materials with respect to airborne chemical concentration. It does not replace assessment of cleaning compatibility, biological contamination or the particular process. Requirements should therefore name the compounds or contamination limits that matter, rather than asking only for a general low-emission label.
Consider particles and cleaning separately
Particles generated by wheel turning, abrasion or damaged edges are a different issue from chemical emissions. Representative traffic and wear evidence are relevant where the floor is a potential particle source. A smooth finish reduces recesses that retain contamination, but it does not make the surface self-cleaning or assign an airborne cleanliness class to the room.
Review the actual detergent, disinfectant concentration, contact time and rinsing method. Gloss retention, chemical resistance and ease of removing residue may influence the choice differently. Continuous coving can simplify the wall junction, while moving joints still require a detail that accommodates movement without creating an inaccessible contamination trap.
Preserve the conductive construction
Self-smoothing behaviour depends on resin viscosity, filler loading, temperature and working time. Adding extra filler to adjust cost or flow can change both appearance and electrical behaviour. The specified film thickness and mixing procedure should be maintained across repairs, edges and open floor areas. Grounding connections and conductive underlayers must remain compatible with any moisture treatment beneath them.
Electrical acceptance should cover the cured floor under the specified environmental conditions. Where people are grounded through their shoes, qualification must include that footwear and floor combination. A conductive material report alone does not establish personnel performance.
Allow curing and commissioning time
Walking readiness, chemical-service readiness and suitability for a contamination-sensitive process need not occur at the same time. Agree the curing, ventilation, cleaning and release sequence before installation. Procurement should include the complete layer schedule, relevant emission and wear evidence, grounding layout and acceptance methods. After repairs or recoating, evaluate both contamination control and electrical performance again because a visually similar replacement may have a different formulation.
Planning your Conductive Epoxy Flooring Low-Emission Cleanroom specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.