Concealed Cleanroom Ceiling Grid 80 mm Clip-In
- Clamping studs locate the cassette edge in the hidden support.
- Narrow joints reduce the visual interruption between adjacent panels.
- Non-walkable construction suits ceilings serviced from below.
Downward-removable cassettes on concealed clamping rails
This non-walkable ceiling uses galvanized steel cassettes with formed L-edges and clamping studs. The reference arrangement has a 600 × 600 mm module, approximately 80 mm system height and a narrow joint of about 1 mm. Hidden carriers retain the cassette edges above the finished plane.
Downward removal is useful when a conventional lay-in tile cannot be lifted into the void. It still requires access for the release tool and enough clear space below to handle the detached cassette safely.
Joint appearance is not sealing performance
A narrow gap gives a compact visual pattern, but gap width alone does not make the ceiling air-tight. Select the panel-joint, perimeter and penetration sealing details for the required room boundary. Where applied sealant is used, access may involve cutting and renewing it.
Align the clamping profiles so that cassette engagement is even and panels are not forced to correct a distorted grid. Damaged studs or bent edges can prevent reliable retention. Use the intended removal method rather than levering against a finished face.
Support and service openings
The approximately 80 mm height describes the selected assembly, not every installation clearance. Suspension, anchors and services can require additional void space. Choose hanger spacing from the actual carrier and loading design rather than using a universal maximum distance.
Coordinate lights, ventilation openings and filters before fabrication. A cut-out removes material from the cassette and may require a special frame or independent equipment support. Do not treat the visible steel sheet as a support for unplanned fixtures.
Quotation, inspection and cleaning
Include panel quantity, finish, carriers, hangers, perimeter trim, service openings, sealing and access tools in the quotation. State whether the contractor must supply structural fixings or independent supports.
At handover, check alignment, complete engagement, safe panel removal, surface condition and any specified leakage result. Maintain from below and keep workers and stored materials off the ceiling. Clean with products compatible with coating and joint materials, inspect edges after access, and renew seals where the selected detail requires it. Cleanroom or fire performance needs documentation for the complete assembly.
Planning your Concealed Cleanroom Ceiling Grid 80 mm Clip-In specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.