Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Compact HPL Cleanroom Door Aluminum-Honeycomb Core
zhengfeng-COMPACT-HPL-CLEANROOM-DOOR-ALUMINUM-HONEYCOMB

Compact HPL Cleanroom Door Aluminum-Honeycomb Core

An HPL-faced lower section with aluminum-honeycomb infill supports a half-glazed manual entrance with an aluminum perimeter.
  • The lower HPL face offers a nonmetallic contact surface.
  • Aluminum edge profiles border the laminate and glazing construction.
  • A bonded cellular core supports the opaque portion of the blade.
Request a Quote Browse Products

Upper glazing with a laminate lower panel

This 50 mm HPL-faced door uses aluminum honeycomb within its opaque section and a broad viewing area above. The metal cellular core supports the laminate faces, while an aluminum perimeter forms the edge and connects the leaf to the hardware arrangement. The lower nonmetallic face can match HPL room finishes; it does not establish an electrically insulating or antistatic door system.

Upper-half glazing can help people observe an occupied doorway, but its lower edge may obscure a low trolley. Set the viewing elevation against the intended users and route. Larger glass area also changes the leaf mass and the available positions for closer reinforcement.

Specify the whole sandwich and glazing assembly

ComponentReference and selection point
Leaf50 mm single manual swing leaf.
Opaque panelCompact HPL faces bonded around aluminum honeycomb; facing grade and thickness specified separately.
Perimeter/surroundAluminum alloy, coordinated with wall thickness and required flushness.
GlazingUpper-half observation area; glass safety construction, seals and retention scheduled together.
Sealing/hardwarePerimeter gasket; stainless lever and overhead closer options. Bottom detail to be selected.

A metallic core does not remove adhesive or sealed joints from the construction. The assembly's suitability for wet cleaning depends on these interfaces as well as the laminate. Select the HPL finish using the actual cleaning agents; surface test data for a particular laminate cannot be assumed for every HPL door.

Support and service access

Provide fixed support behind the hinge jamb and approved reinforcement for the closer. Hardware screwed only into a decorative face can loosen under repeated cycling. Keep the frame square so the gasket compresses evenly, and coordinate the bottom clearance with the room's pressure-control design.

During maintenance inspect the laminate-to-profile joints and glazing seals for opening or deterioration. A cracked lower face can expose the internal sandwich even when the surrounding aluminum remains intact. Clean using compatible methods and address frequent trolley strikes through the route layout or specified protection, rather than assuming the lower HPL is a collision barrier.

Procurement and handover

Quote the finished leaf size, HPL sample, glass assembly, frame, hardware, seals, opening reinforcement and fitting. Check the finished clear passage, glass viewing height, secure retention and latch operation. A closer should be adjusted with the ventilation running; good performance with the room unpressurized may not represent daily service. Fire, acoustic and air-leakage claims require evidence for the selected complete assembly.

Planning your Compact HPL Cleanroom Door Aluminum-Honeycomb Core specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us