Cleanroom Wall Base Channel 50 mm Folded-Steel Fixed
- Folded hems finish both upper leg edges.
- Direct anchoring locates the wall base on the substrate.
- 3000 mm sections provide practical handling lengths.
A fixed folded track at floor level
The galvanized-steel channel locates a cleanroom wall panel on a prepared floor substrate. Its nominal 50 × 50 × 50 mm section is formed from 0.5 mm sheet, with 10 mm folded-and-crushed hems along both upper leg edges. The hems finish the exposed edges and locally stiffen them; they do not establish a structural load rating for the track.
Fit the panel to the finished channel
Check the clear opening after folding, hemming and any surface finish. A nominal 50 mm wall panel is not guaranteed to fit a channel merely labeled 50 mm. Bend radii, hems and panel tolerances can affect insertion and the space available for sealing.
The fixed base has no built-in levelling adjustment. Survey the floor along the wall line and resolve uneven areas through the approved support detail before anchoring. Do not pull a thin base down over a hollow area and expect the wall panel to bridge it without assessment.
Anchor and seal both interfaces
Choose anchors for the actual substrate and wall reactions, checking concealed services before drilling. The channel-to-floor seal and panel-to-channel seal are separate interfaces. Continue them through splices, corners and door returns so water or air cannot bypass an otherwise neat straight run.
White polyester or panel-matching laminate finishes can be specified. Protect cut edges and remove steel swarf to limit staining and coating damage. Fixed track does not necessarily prevent later panel removal, but the head detail, panel engagement and release sequence must permit it.
Order and inspection requirements
Provide wall thickness, floor condition, anchor design, finish and cut schedule. Sections around the 3000 mm reference length can be coordinated with handling and joint locations. Quote track, finishing, cuts, anchors, packing and sealants explicitly. Acceptance should include fitted panel clearance, floor contact, anchor engagement, wall line and complete seals. Inspect the lower edge for trapped moisture, corrosion or renewed movement during routine maintenance.
Planning your Cleanroom Wall Base Channel 50 mm Folded-Steel Fixed specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.