Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom Wall Access Panel 600 mm Dual-Seal
zhengfeng-CLEANROOM-WALL-ACCESS-600-DUAL-SEAL

Cleanroom Wall Access Panel 600 mm Dual-Seal

A broad coated-steel wall leaf provides an uninterrupted 549 mm access aperture, with support and gasket compression specified for the complete opening.
  • The large clear aperture improves access to grouped services.
  • One leaf avoids a central meeting stile.
  • A powder-coated surface finishes the steel door and frame.
Request a Quote Browse Products

One broad opening for grouped wall services

The 600 mm dual-seal panel gives a listed 549 x 549 mm clear access aperture without a central meeting stile. It can serve a group of instruments or connections where several small hatches would divide the working area. The single broad leaf also needs space to open and stronger attention to frame alignment; more opening area is useful only when the services remain reachable behind it.

Dimensions and configuration

ElementReference selection
Door600 x 600 mm single leaf.
Structural opening610 x 610 mm.
Clear aperture549 x 549 mm, subject to the delivered hardware and open position.
Metal and finishZintec steel, polyester powder coated.
SealContinuous dual-gasket arrangement.
BorderPicture-frame or beaded frame, selected for the wall finish.

Do not treat this opening as a personnel passage or equipment hatch solely because it is the largest listed size. Check the intended component's three-dimensional removal path, its support during removal and the surrounding room's working space. A 549 mm clear square is smaller than either the nominal door or wall cut-out.

Broad-leaf support and pressure behaviour

A larger leaf exposes more area to a given pressure difference, while its perimeter needs consistent alignment to compress both seals. Select the hinges, closing hardware and frame support for the actual size and pressure direction. Ratings from a smaller tested panel cannot be extended automatically to this one.

Reinforce the opening within the wall system and keep the frame square while fixing it. Do not hang service pipes or cable trays from the access frame unless that load is expressly included in the design. The frame-to-wall joint remains a separate sealing boundary from the leaf gaskets.

Grouped services still need individual maintenance routes

Plan isolation and component replacement so work on one circuit does not require uncontrolled disturbance of neighbouring services. Place frequently adjusted items within reach and leave the hinge-side space clear. If the leaf swing obstructs a route, consider a different access arrangement rather than relying on removal of the door at every visit.

Inspect all gasket contact areas after service, especially corners and the far edge of the broad leaf. Rubbing or uneven gaps may indicate frame movement rather than a worn latch. Protect the powder coating and use compatible cleaning products; coating type alone does not establish antimicrobial performance.

Purchase and acceptance requirements

Provide wall construction, service layout, leaf swing, hardware, gasket requirements and required leakage criteria with the inquiry. State the scope for reinforcement, site installation, perimeter sealing and tests. Acceptance should demonstrate the actual service task, secure frame attachment, repeated full engagement and the agreed pressure-boundary performance. A single uninterrupted aperture and two seals do not confer a fire rating or cleanroom classification.

Planning your Cleanroom Wall Access Panel 600 mm Dual-Seal specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us