Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom Wall Access Panel 300 mm Dual-Seal
zhengfeng-CLEANROOM-WALL-ACCESS-300-DUAL-SEAL

Cleanroom Wall Access Panel 300 mm Dual-Seal

A compact coated-steel access leaf uses two gasket interfaces, with its 249 mm clear aperture checked against the complete inspection task.
  • A compact aperture suits local inspection points.
  • Dual seals provide two closure interfaces around the leaf.
  • The coated steel surface gives a consistent exposed finish.
Request a Quote Browse Products

A small access door for local inspection

The 300 mm dual-seal wall panel provides access to a local instrument, small connection or inspection point without removing a broad section of the wall. Its coated Zintec steel leaf closes against two gasket lines. The seals create successive contact interfaces; their number alone does not state the leakage rate or provide two independently verified containment barriers.

Use the clear opening for the service task

Dimension or featureCatalog reference
Door size300 x 300 mm.
Structural opening310 x 310 mm.
Accessible opening249 x 249 mm; allow for the actual hinge, opening angle and workpiece.
ConstructionSingle Zintec steel leaf, polyester powder coating.
SealDual gasket, with material and compression detail selected for the application.
Frame optionsPicture-frame or beaded perimeter.

These dimensions describe different interfaces and are not interchangeable cutting instructions. A component that fits through a 249 mm square may still be impossible to remove if the pipe union or hand tool needs additional turning space behind the wall. Check the entire service motion before choosing the smallest panel.

Frame choice and wall continuity

A picture-frame border covers the perimeter edge; a beaded frame is intended to be integrated into a compatible wall finish. Neither option automatically suits every metal-faced cleanroom panel. Detail the mounting depth, backing and cleanable perimeter with the wall supplier, especially if the wall has a fire or pressure-boundary function.

Anchor the frame without pulling it out of square. Frame-to-wall sealing closes a different leak path from the two leaf gaskets. Keep finishing compound, paint and debris off both contact lines, and provide the specified latch action rather than overtightening to compensate for distortion.

Cleaning and acceptance

Inspect gaskets for cuts, flattening or chemical swelling. Clean the powder coating with a compatible process, paying attention to lower edges where liquid can collect. Polyester coating does not, by itself, establish antibacterial performance. Replace damaged seals with the correct profile instead of adding an improvised foam strip.

For a quote, provide wall thickness and construction, actual access requirement, frame style, closure, finish and any leakage criterion. Identify opening reinforcement, installation, sealing and tests separately. At handover, demonstrate access to the intended component, repeated closing and continuous gasket contact. Where air leakage is specified, test the installed assembly under the agreed conditions; no pressure class or fire rating is established by the dual-seal name.

Planning your Cleanroom Wall Access Panel 300 mm Dual-Seal specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us