Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom U-Channel Edge Trim 75 mm Panel
zhengfeng-CLEANROOM-U-EDGE-TRIM-75

Cleanroom U-Channel Edge Trim 75 mm Panel

A nominal 75 mm U-channel selected by its finished opening and the actual panel edge.
  • The intermediate-size family provides an alternative to narrow and wide edge channels.
  • Continuous side legs cover the panel termination along the run.
  • Anodizing or powder coating can coordinate the exposed metal surface.
Request a Quote Browse Products

A 75 mm channel family for panel-edge closure

This U-shaped aluminum extrusion closes the end of an intermediate-depth cleanroom panel. Its base covers the exposed edge and the parallel legs overlap the adjoining panel faces. The nominal 75 mm designation identifies the family; the finished receiving clearance determines the actual fit.

Choose the gauge with the section dimensions

6063 aluminum in T5 or T6 temper can be considered. Proposed wall gauges span 0.8–5.0 mm, but each gauge requires its own viable section and connection detail. If the outside width remains fixed, thicker side walls leave less internal room. The extrusion drawing must therefore state both the opening and the overall envelope.

A thin leg is easier to deform during installation, while a thicker leg changes weight, edge projection and fixing requirements. Temper selection does not remove those geometric trade-offs. Check inside radii against the panel corners so the base can seat without crushing the skin or core.

Finish before approving the fit

Anodized or powder-coated finishes can be specified. The proposed film ranges, 8–25 µm for anodizing and 40–120 µm for powder coating, are options to narrow to a selected system. They are not a blanket resistance claim. Establish the required clearance on the finished part and assess the surface with the intended cleaning products.

Use 3000–6000 mm length proposals or shorter cuts according to the handling route and termination schedule. Remove burrs and keep the core enclosed. Seal the longitudinal overlaps and end joints where required by the enclosure design, using a detail that remains accessible for inspection.

Purchase and acceptance

Provide the actual panel thickness range, edge geometry, mounting orientation and attachment method. The quotation should distinguish the chosen extrusion, finish, cut lengths, drilled features and seals. Accept the supplied gauge and finished opening against the approved drawing, then trial-fit a panel sample. Inspect for loose legs, damaged coating and opened end seals during routine maintenance.

Planning your Cleanroom U-Channel Edge Trim 75 mm Panel specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us