Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom U-Channel Edge Trim 100 mm Panel
zhengfeng-CLEANROOM-U-EDGE-TRIM-100

Cleanroom U-Channel Edge Trim 100 mm Panel

A wide single receiver with a continuous closing base and a defined panel-edge fit.
  • A nominal 100 mm family for broad panel-edge terminations.
  • One continuous base closes the broad panel end.
  • The simple U shape avoids a second unused receiving side.
Request a Quote Browse Products

Close a broad panel end with one receiving channel

The nominal 100 mm U-section terminates a thick cleanroom panel against a continuous aluminum base. Its two legs overlap the panel faces, providing a defined edge finish without leaving a second receiving side open. This makes the interface different from an H-connector joining two panels.

Control the opening and the broad base

Specify the finished inside width, leg depth and corner radii for the actual panel build-up. The 100 mm family label is not a guaranteed clear opening. If the channel must fit over skins, coatings or an edge reinforcement, include those layers in the dimensioned section.

Proposed 6063 T5 or T6 material and 0.8–5.0 mm wall gauges require selection for the intended detail. The broad base can be distorted by concentrated fixings or uneven packing. A heavier gauge may improve resistance to local deformation but also changes clearances and does not establish the load capacity of the surrounding panel.

Consider the termination environment

Define whether the channel is a vertical end closure, a head detail or another perimeter component. A horizontal location exposed to cleaning liquid needs its own sealing and water-management design. A U-shaped cover is not automatically a waterproof floor track.

Anodized and powder-coated finishes are options, with proposed film ranges of 8–25 µm and 40–120 µm respectively. Select one coating specification and assess compatibility with cleaning agents. Where a continuous metal closure bridges a temperature-controlled panel, include that path in the junction thermal assessment.

Installation, supply and handover

Coordinate 3000–6000 mm length proposals or pre-cut sections with transport and the joint layout. Keep fastening heads clear of the panel seat, remove swarf and seal the required longitudinal and end interfaces. Quote the selected section, coating, machining, fixing system and seals. Acceptance should verify the broad base remains straight, the panel fits without forced spreading and all designated closures are complete. Maintenance checks should focus on distorted legs, pooled residue at horizontal ends and failed seals.

Planning your Cleanroom U-Channel Edge Trim 100 mm Panel specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us